You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Using the Remote Control<br />
3. Use the remote buttons that apply to that device.<br />
Notes: The remote control may not be <strong>com</strong>patible with all brands and models of devices.<br />
Modes of Operation<br />
The button corresponding to the mode the remote is in lights up when you press any button that works in<br />
that mode. For example, if you’re in TV mode and you press the VOL+ button, the TV button lights up.<br />
This tells you that the <strong>com</strong>mand to increase the volume is being sent to the TV (and not the satellite receiver,<br />
for example).<br />
Volume Punchthrough Feature<br />
You may find this feature helpful if you’ve connected your devices to an audio system, and you want to<br />
use the TV’s remote control to operate the volume for a device that is connected to the audio system. An<br />
example follows:<br />
Let’s say you’ve connected your DVD player to your audio system. You’ve also programmed your TV remote<br />
control to operate your DVD player. Since the DVD player sends its volume through the audio system, you<br />
would have to bounce back and forth between two remote controls: the audio system’s remote to adjust the<br />
volume and the TV’s remote control to operate the DVD player.<br />
The Volume Punchthrough feature eliminates the need for you to use two remote controls and saves a button<br />
press when you’re using the TV remote to adjust the volume. In effect, you are telling the TV remote to<br />
retrieve and send volume <strong>com</strong>mands from the audio system whenever the TV remote is in DVD mode.<br />
Therefore, after you’ve successfully set up the Volume Punchthrough feature, whenever the TV remote is in<br />
DVD mode (press the DVD button) and you want to adjust the volume, you only have to press the VOL<br />
+/- or MUTE buttons. Follow the instructions below to set up Volume Punchthrough.<br />
1. On your remote control, simultaneously press and hold the ON•OFF and MUTE buttons<br />
(approximately 3 seconds) until a device button remains lit. Then release the buttons.<br />
2. Press and hold the MUTE button until the device button blinks off, then release the MUTE button.<br />
3. Press and release the device button that you programmed to operate the audio system (receiver or<br />
amplifier).<br />
4. Press and release the MUTE button.<br />
5. Now, test it by turning on your audio system.<br />
6. Turn on the device that is connected to the audio system (satellite receiver, for example).<br />
7. Put the TV’s remote in SAT•CABLE mode by pressing the SAT•CABLE button.<br />
8. Press VOL+ or VOL-. The volume from the audio system should increase or decrease accordingly.<br />
32 Chapter 2