HAHN+KOLB-Toolcatalog 2011/12 – Testing equipment

Contour and roughness measurements
Surface-roughness measuring devices
Continued next page
Options for roughness measuring units
DIAVITE DH-8 and DIAVITE COMPACT II
•diamond probe 5 μm/60°
•calibration masters
•cross table KRT
•PC software DIASOFT Standard and Expert: for transmission and archiving the measured values in a PC, showing the roughness and Abbott curves, waviness
and roughness profiles on the same curve, symmetry, profile comparison, etc.
Only for roughness measuring units DIAVITE DH-8 VHF:
•DIAVITE Kontur: expansion modules for additional measurements and evaluations of contours. Measuring ranges: X = 0.5-15 mm, Z = 6 mm, max. probe angle
rising/falling 77°/88°
•DIAVITE OPTIC: high-resolution optical white-light sensor, suitable for surface-roughness measurements without contact yet with the highest precision for
almost all materials, especially for complex and sensitive surfaces, beam-Ø 7 μm, vertical measuring range 400 μm (depends on the measuring frequency and
the reflection from the workpiece), max. incline ±30°, repeat precision up to 2 nm
DIAVITE Kontur: Contour tracer CH
Testing equipment
DIAVITE Kontur: Contour analysis
h Additional information, advice or quotation available on request.
t Technical Hotline +49 (0)711 9813-366
DIAVITE Optic: White-light sensor mounted on the
feed unit VHF
Roughness evaluation with DIASOFT-Standard
Continued next page
Accessories for roughness measuring units
DIAVITE DH-8 and DIAVITE COMPACT II
•Measuring stand, natural-stone base, with column Ø 20 mm, height 250 mm, and adapter for feed
units VH/VHF
•Miniature precision vices, with thread spindle plane parallelism of the Vee blocks 0.02 mm, replaceable
pairs of clamping jaws made from hardened steel or plastic material. Additional clamping and alignment
options using vertical and horizontal Vee blocks at the clamping jaws of the fixed parts of the vice and
groove along the long sides.
•Skid-type and reference-surface probes 1)
No. 47000 500 and 505
Designation 44805 44805 47000
Ident. No. Set pr. E U. pr. E U. pr. E
Recording paper for integral printer
110 O. R. – –
1 set of=10rolls
Miniature precision vice
500 – – O. R.
Dimensions L x W x H: 50 x 15 x 15 mm
Clamping with / clamping depth 14 / 8 mm
brass, matt chrome-plate
Miniature precision vice
505 – – O. R.
Dimensions L x W x H: 75 x 25 x 25 mm
Clamping with / clamping depth 23 / 15 mm
aluminium, matt anodised
Standard buttons SH 550 – (O. R.) –
Free slot gauge NFH 2) 565 – (O. R.) –
Example of application: Measuring stand + feed unit VHF +
Mini-vice + cross table (on request)