Manual NISE 3500 - ICPDAS-EUROPE

More documents

Recommendations

Info

Appendix D: Intel Embedded AMT Management Express KVM 4. Click the first icon in the toolbar (top row). 5. Enter a range of IP addresses that is within the network to find iAMT computers. 6. Click the Start Scan icon. Copyright © 2011 NEXCOM International Co., Ltd. All Rights Reserved. 91 NISE 3500, NISE 3500M User Manual
Appendix D: Intel Embedded AMT Management Express KVM 7. The iAMT computers that were detected within the network will appear under the Discovered Devices list. 8. Click Add Device. A dialog box will appear. Enter the ME BIOS’ username “admin” and password. Click OK. 9. After you have added the iAMT computer, a dialog box will appear informing you that the device was added successfully. Click OK. Copyright © 2011 NEXCOM International Co., Ltd. All Rights Reserved. 92 NISE 3500, NISE 3500M User Manual
Page 1 and 2:
NEXCOM International Co., Ltd. Indu
Page 3 and 4:
Contents Serial Interface (COM 1 -
Page 5 and 6:
Preface RoHS Compliance NEXCOM RoHS
Page 7 and 8:
Preface Warnings Read and adhere to
Page 9 and 10:
Preface Technical Support and Assis
Page 11 and 12:
Preface China-Beijing Room 301, Blo
Page 13 and 14:
Preface Ordering Information The fo
Page 15 and 16:
Chapter 1: Product Introduction NIS
Page 17 and 18:
Chapter 1: Product Introduction Pow
Page 19 and 20:
Chapter 1: Product Introduction Rea
Page 21 and 22:
Chapter 2: Jumpers and Connectors T
Page 23 and 24:
1 1 1 Locations of the Jumpers and
Page 25 and 26:
Jumpers Clear CMOS Connector size:
Page 27 and 28:
IEEE1394b Connector (NISE 3500M onl
Page 29 and 30:
ATX Power On/Off Switch Connector l
Page 31 and 32:
9V-30V DC Input Connector type: POW
Page 33 and 34:
COM1 (RS232) labelled “A“ on DB
Page 35 and 36:
USB Ports Connector type: Dual USB
Page 37 and 38:
Mic-in Jack Connector size: 5-pin j
Page 39 and 40:
SMBus DATA/CLK Pin Header Connector
Page 41 and 42:
LVDS Backlight Connector Connector
Page 43 and 44:
SATA DOM Power Connectors Connector
Page 45 and 46:
Line-in Connector Connector type: 1
Page 47 and 48:
Parallel Connector Connector size:
Page 49 and 50:
Installing a DIMM 1. Push the eject
Page 51 and 52:
Installing the CPU 1. The CPU socke
Page 53 and 54: 5. Before you install the heat sink
Page 55 and 56: 4. Place the SATA hard drive on the
Page 57 and 58: Installing a Half Length SATA DOM w
Page 59 and 60: Installing a Full Length SATA DOM I
Page 61 and 62: Wallmount Brackets The wallmount br
Page 63 and 64: Default Configuration Most of the c
Page 65 and 66: Advanced The Advanced menu allows y
Page 67 and 68: Limit CPUID Maximum The CPUID instr
Page 69 and 70: USB Configuration This section is u
Page 71 and 72: AMT Configuration This section is u
Page 73 and 74: South Bridge SB Chipset Configurat
Page 75 and 76: Boot Main Advanced Boot Configurati
Page 77 and 78: Chapter 5: AMT Settings Enable Inte
Page 79 and 80: 3. Enter a new password in the spac
Page 81 and 82: 7. Select Network Setup and then pr
Page 83 and 84: 11. In the TCP/IP Settings menu, se
Page 85 and 86: 15. Select Default Gateway Address
Page 87 and 88: 19. In the Intel(R) ME Platform Con
Page 89 and 90: 23. Select Previous Menu until you
Page 91 and 92: 27. In the SOL/IDER menu, select SO
Page 93 and 94: 31. Select Previous Menu until you
Page 95 and 96: 35. Select Previous Menu. Intel(R)
Page 97 and 98: 3. The message below will appear. T
Page 99 and 100: Appendix A: Power Consumption Power
Page 101 and 102: Appendix C: Watchdog Timer Setting
Page 103: Appendix D: Intel Embedded AMT Mana
Page 107 and 108: Appendix D: Intel Embedded AMT Mana
Page 109 and 110: Appendix D: Intel Embedded AMT Mana
Page 111 and 112: Appendix E: Intel Manageability Com
Page 117 and 118: Appendix F: External Anti-vibration
Page 119 and 120: Appendix F: External Anti-vibration
show all

Manual NISE 3500 - ICPDAS-EUROPE

Create successful ePaper yourself

Delete template?

Save as template?