Manual NISE 3500 - ICPDAS-EUROPE

More documents

Recommendations

Info

SATA Ports Connector type: Standard Serial ATAII 7P (1.27mm, SATA-M-180) Connector location: CN12 and CN13 1 7 Pin Definition 1 GND 2 SATA_TXP1 3 SATA_TXN1 4 GND 5 SATA_RXN1 6 SATA_RXP1 7 GND SATA Power Connectors Connector type: 4-pin Wafer, 2.54mm-M-180 Connector location: CN14 and CN15 1 4 Pin Definition 1 +12V 2 GND 3 GND 4 VCC5 Copyright © 2011 NEXCOM International Co., Ltd. All Rights Reserved. 29 NISE 3500, NISE 3500M User Manual
SATA DOM Power Connectors Connector type: 1x2 2-pin JST wafer, 2.54mm pitch Connector location: J16 and J17 USB Port Connector Connector type: 6-pin boxed header, JST-2.0mm-M-180 Connector location: J12 1 2 1 Pin Definition 1 +12V 2 GND 6 Pin Definition 1 +5V 2 USB10- 3 USB10+ 4 USB11- 5 USB11+ 6 GND Copyright © 2011 NEXCOM International Co., Ltd. All Rights Reserved. 30 NISE 3500, NISE 3500M User Manual
Page 1 and 2: NEXCOM International Co., Ltd. Indu
Page 3 and 4: Contents Serial Interface (COM 1 -
Page 5 and 6: Preface RoHS Compliance NEXCOM RoHS
Page 7 and 8: Preface Warnings Read and adhere to
Page 9 and 10: Preface Technical Support and Assis
Page 11 and 12: Preface China-Beijing Room 301, Blo
Page 13 and 14: Preface Ordering Information The fo
Page 15 and 16: Chapter 1: Product Introduction NIS
Page 17 and 18: Chapter 1: Product Introduction Pow
Page 19 and 20: Chapter 1: Product Introduction Rea
Page 21 and 22: Chapter 2: Jumpers and Connectors T
Page 23 and 24: 1 1 1 Locations of the Jumpers and
Page 25 and 26: Jumpers Clear CMOS Connector size:
Page 27 and 28: IEEE1394b Connector (NISE 3500M onl
Page 29 and 30: ATX Power On/Off Switch Connector l
Page 31 and 32: 9V-30V DC Input Connector type: POW
Page 33 and 34: COM1 (RS232) labelled “A“ on DB
Page 35 and 36: USB Ports Connector type: Dual USB
Page 37 and 38: Mic-in Jack Connector size: 5-pin j
Page 39 and 40: SMBus DATA/CLK Pin Header Connector
Page 41: LVDS Backlight Connector Connector
Page 45 and 46: Line-in Connector Connector type: 1
Page 47 and 48: Parallel Connector Connector size:
Page 49 and 50: Installing a DIMM 1. Push the eject
Page 51 and 52: Installing the CPU 1. The CPU socke
Page 53 and 54: 5. Before you install the heat sink
Page 55 and 56: 4. Place the SATA hard drive on the
Page 57 and 58: Installing a Half Length SATA DOM w
Page 59 and 60: Installing a Full Length SATA DOM I
Page 61 and 62: Wallmount Brackets The wallmount br
Page 63 and 64: Default Configuration Most of the c
Page 65 and 66: Advanced The Advanced menu allows y
Page 67 and 68: Limit CPUID Maximum The CPUID instr
Page 69 and 70: USB Configuration This section is u
Page 71 and 72: AMT Configuration This section is u
Page 73 and 74: South Bridge SB Chipset Configurat
Page 75 and 76: Boot Main Advanced Boot Configurati
Page 77 and 78: Chapter 5: AMT Settings Enable Inte
Page 79 and 80: 3. Enter a new password in the spac
Page 81 and 82: 7. Select Network Setup and then pr
Page 83 and 84: 11. In the TCP/IP Settings menu, se
Page 85 and 86: 15. Select Default Gateway Address
Page 87 and 88: 19. In the Intel(R) ME Platform Con
Page 89 and 90: 23. Select Previous Menu until you
Page 91 and 92: 27. In the SOL/IDER menu, select SO
Page 93 and 94:
31. Select Previous Menu until you
Page 95 and 96:
35. Select Previous Menu. Intel(R)
Page 97 and 98:
3. The message below will appear. T
Page 99 and 100:
Appendix A: Power Consumption Power
Page 101 and 102:
Appendix C: Watchdog Timer Setting
Page 103 and 104:
Appendix D: Intel Embedded AMT Mana
Page 105 and 106:
Page 107 and 108:
Page 109 and 110:
Page 111 and 112:
Appendix E: Intel Manageability Com
Page 113 and 114:
Page 115 and 116:
Page 117 and 118:
Appendix F: External Anti-vibration
Page 119 and 120:
Appendix F: External Anti-vibration
show all

Manual NISE 3500 - ICPDAS-EUROPE

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?