Manual NISE 3500 - ICPDAS-EUROPE

More documents

Recommendations

Info

Status Indicators PWR LAN1/LAN2 Link/Active LED Connector location: LED1 and LED2 LINK1 LINK2 HDD Status LED Color PWR Green HDD Yellow ACT1 ACT2 Pin Definition C1 LAN2_LINK_N C2 LAN2_ACT_N A1 LAN2_LINK_P A2 LAN2_ACT_P Copyright © 2011 NEXCOM International Co., Ltd. All Rights Reserved. 15 NISE 3500, NISE 3500M User Manual
ATX Power On/Off Switch Connector location: SW1 Pin Definition On Blue light Off Red light Pin Definition Pin Definition 1 GND 2 PBT_PU 3 PBT_PU 4 GND A1 PWRLED_N C1 PWRLED_P Copyright © 2011 NEXCOM International Co., Ltd. All Rights Reserved. 16 NISE 3500, NISE 3500M User Manual
Page 1 and 2: NEXCOM International Co., Ltd. Indu
Page 3 and 4: Contents Serial Interface (COM 1 -
Page 5 and 6: Preface RoHS Compliance NEXCOM RoHS
Page 7 and 8: Preface Warnings Read and adhere to
Page 9 and 10: Preface Technical Support and Assis
Page 11 and 12: Preface China-Beijing Room 301, Blo
Page 13 and 14: Preface Ordering Information The fo
Page 15 and 16: Chapter 1: Product Introduction NIS
Page 17 and 18: Chapter 1: Product Introduction Pow
Page 19 and 20: Chapter 1: Product Introduction Rea
Page 21 and 22: Chapter 2: Jumpers and Connectors T
Page 23 and 24: 1 1 1 Locations of the Jumpers and
Page 25 and 26: Jumpers Clear CMOS Connector size:
Page 27: IEEE1394b Connector (NISE 3500M onl
Page 31 and 32: 9V-30V DC Input Connector type: POW
Page 33 and 34: COM1 (RS232) labelled “A“ on DB
Page 35 and 36: USB Ports Connector type: Dual USB
Page 37 and 38: Mic-in Jack Connector size: 5-pin j
Page 39 and 40: SMBus DATA/CLK Pin Header Connector
Page 41 and 42: LVDS Backlight Connector Connector
Page 43 and 44: SATA DOM Power Connectors Connector
Page 45 and 46: Line-in Connector Connector type: 1
Page 47 and 48: Parallel Connector Connector size:
Page 49 and 50: Installing a DIMM 1. Push the eject
Page 51 and 52: Installing the CPU 1. The CPU socke
Page 53 and 54: 5. Before you install the heat sink
Page 55 and 56: 4. Place the SATA hard drive on the
Page 57 and 58: Installing a Half Length SATA DOM w
Page 59 and 60: Installing a Full Length SATA DOM I
Page 61 and 62: Wallmount Brackets The wallmount br
Page 63 and 64: Default Configuration Most of the c
Page 65 and 66: Advanced The Advanced menu allows y
Page 67 and 68: Limit CPUID Maximum The CPUID instr
Page 69 and 70: USB Configuration This section is u
Page 71 and 72: AMT Configuration This section is u
Page 73 and 74: South Bridge SB Chipset Configurat
Page 75 and 76: Boot Main Advanced Boot Configurati
Page 77 and 78: Chapter 5: AMT Settings Enable Inte
Page 79 and 80:
3. Enter a new password in the spac
Page 81 and 82:
7. Select Network Setup and then pr
Page 83 and 84:
11. In the TCP/IP Settings menu, se
Page 85 and 86:
15. Select Default Gateway Address
Page 87 and 88:
19. In the Intel(R) ME Platform Con
Page 89 and 90:
23. Select Previous Menu until you
Page 91 and 92:
27. In the SOL/IDER menu, select SO
Page 93 and 94:
31. Select Previous Menu until you
Page 95 and 96:
35. Select Previous Menu. Intel(R)
Page 97 and 98:
3. The message below will appear. T
Page 99 and 100:
Appendix A: Power Consumption Power
Page 101 and 102:
Appendix C: Watchdog Timer Setting
Page 103 and 104:
Appendix D: Intel Embedded AMT Mana
Page 105 and 106:
Page 107 and 108:
Page 109 and 110:
Page 111 and 112:
Appendix E: Intel Manageability Com
Page 113 and 114:
Page 115 and 116:
Page 117 and 118:
Appendix F: External Anti-vibration
Page 119 and 120:
Appendix F: External Anti-vibration
show all

Manual NISE 3500 - ICPDAS-EUROPE

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?