Manual NISE 3500 - ICPDAS-EUROPE
Manual NISE 3500 - ICPDAS-EUROPE
Manual NISE 3500 - ICPDAS-EUROPE
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
USB Configuration<br />
This section is used to configure USB devices.<br />
Advanced<br />
USB Configuration<br />
USB Devices:<br />
1 Mouse, 1 Hub<br />
Legacy USB Support<br />
EHCI Hand-off<br />
Device Reset Timeout<br />
BIOS SETUP UTILITY<br />
[Enabled]<br />
[Enabled<br />
[20 Sec]<br />
Enables Legacy USB<br />
support. AUTO option<br />
disables legacy support if<br />
no USB devices are<br />
connected. DISABLE<br />
option will keep USB<br />
devices available only for<br />
EFI applications.<br />
Super IO Configuration<br />
This section is used to configure the I/O functions supported by the onboard<br />
Super I/O chip.<br />
Advanced<br />
Super IO Configuration<br />
Super IO Chip<br />
Serial Port 0 Configuration<br />
Serial Port 1 Configuration<br />
Serial Port 2 Configuration<br />
Serial Port 3 Configuration<br />
Serial Port 4 Configuration<br />
Parallel Port Configuration<br />
BIOS SETUP UTILITY<br />
ITE IT8783F<br />
Set Parameters of Serial<br />
Port 1 (COMA)<br />
Version 2.00.1201. Copyright (C) 2009 American Megatrends, Inc.<br />
→ ←: Select Screen<br />
↑↓: Select Item<br />
Enter: Select<br />
+/-: Change Opt.<br />
F1: General Help<br />
F2: Previous Values<br />
F3: Optimized Defaults<br />
F4: Save ESC: Exit<br />
Legacy USB Support<br />
Enabled Enables legacy USB.<br />
Auto Disables support for legacy when no USB devices are connected.<br />
Disabled Keeps USB devices available only for EFI applications.<br />
EHCI Hand-off<br />
This is a workaround for OSes that does not support EHCI hand-off. The<br />
EHCI ownership change should be claimed by the EHCI driver.<br />
Device Reset Timeout<br />
Selects the USB mass storage device start unit command timeout.<br />
Version 2.00.1201. Copyright (C) 2009 American Megatrends, Inc.<br />
→ ←: Select Screen<br />
↑↓: Select Item<br />
Enter: Select<br />
+/-: Change Opt.<br />
F1: General Help<br />
F2: Previous Values<br />
F3: Optimized Defaults<br />
F4: Save ESC: Exit<br />
Serial Port 0 Configuration to Serial Port 4 Configuration<br />
Selects the IO/IRQ setting of the I/O devices.<br />
Parallel Port Configuration<br />
Configures the parallel port.<br />
Copyright © 2011 NEXCOM International Co., Ltd. All Rights Reserved. 55 <strong>NISE</strong> <strong>3500</strong>, <strong>NISE</strong> <strong>3500</strong>M User <strong>Manual</strong>