Part III: Flare Reduction Project Family - IPIECA

More documents

Recommendations

Info

Section 7. Flare Reduction Project Family Table 7-11. Applicability and History of Approved CDM Baseline Methodologies for flare reduction projects, continued Methodology Version AMS-III.P 01 19 October 2007 Date Approved History of Methodology Development and Revisions Notes Initial Adoption. Applicable to project activities at existing refineries that develop an alternate use for the energy content of waste gas that is being flared in order to generate process heat, replacing fossil fuel combustion. The following conditions apply to this methodology: • Recovered waste gases are used in the same refinery facility; • The project activity does not lead to an increase in the production capacity of the refinery; • Waste gas flow and composition are measureable; • There should not be any addition of fuel gas or refinery gas in the waste gas pipeline between the point of recovery and the point where it is mixed in the fuel gas system or used directly in an elemental process; and • The recovery device is placed just before the flare header and after all the waste gas generation devices. The methodology is limited to applications that result in emission reductions of less than or equal to 60 ktonnes CO 2 equivalent annually. October 2009 62
American Petroleum Institute International Petroleum Industry Environmental Conservation Association
Page 1 and 2:
Prepared by URS Corporation Oil and
Page 3 and 4:
Table of Contents PART I 1 ........
Page 5 and 6:
Section 7. Flare Reduction Project
Page 7 and 8:
Page 9 and 10:
Page 11 and 12:
Page 13 and 14:
Page 15 and 16: Section 7. Flare Reduction Project
Page 21 and 22: ATTACHMENTS TO SECTION 7: FLARE RED
Page 65: Section 7. Flare Reduction Project
show all

Part III: Flare Reduction Project Family - IPIECA

Create successful ePaper yourself

Delete template?

Save as template?