TM/TMC/RM/RMC-2040GE Progressive Scan Cameras - JAI Pulnix

Page 27
TM/RM-2040GE Software
5 GigE Series Camera Serial Commands
You can control the GigE series cameras by serial command either using RS-232 or Camera Link. The
Start character is always “:” and the End character is always (return). For example, to set
Asynchronous Pulse Width Mode, send the command :ASH=9 to the camera. Table 4 lists serial
commands that can be used to control the camera.
TABLE 4.
TM/TMC/RM/RMC-2040 Command List
Command Parameter End of Cmd Ack. Response Description
Scan Mode
:SMD X :o Set Preset Scan Area (X=A,B,C,D,T)
:SMDU= XXXXYYYY :o Set Programmable Scan Area
(XXXX=0000 - 04AF, YYYY=0001 -
04B0)
:SMD? :oMD[X] Inquire current scan mode
(X=A,B,C,D,T,U)
Shutter Mode and Shutter Speed
:MSH= X :o Set Continuous Mode Preset Shutter
( X= 0)
:DSH= XXX :o Set Continuous Mode Programmable
Shutter ( XXX=000 - total lines)
:ASH= X :o Set Async Mode Preset Shutter (X=0, 9,
A, B) ( X=0 async no shutter)
( X=9 PWC, X=A Fixed exposure PIV,
X=B PWC PIV)
:ADS= XXX :o Set Async Mode Programmable Shutter
(XXX=000 - 81F)
:SHR? :o[shtr] Inquire current shutter mode
Gain and Offset
:MGA= XXX :o Set Master Gain
(XXX = 000 - FFF)
:MGB= XXX :o Set R channel Fine Gain
(XXX = 000 - FFF)
:VRA= XXX :o Set Master Offset
(XXX = 000 - FFF)
:VRB= XXX :o Set R channel Fine Offset
(XXX = 000 - FFF)
:MGA? :oMG[XXX]
Inquire Master Gain
(XXX = 000 - FFF)
:MGB? :oSG[XXX] Inquire R channel Fine Gain (XXX = 000
- FFF)
GigE Series Camera Serial Commands