Manual - E-LAB Computers

More documents

Recommendations

Info

UPP1-X In-Circuit Programmer with USB-2 ADDENDUM XMega Attention: The RESET line on the target must never be loaded with capacitors because the PDI-CLK is fed here with > 1MHz. A jumper which disconnects RESET condenser at programming time can help. With older XMegas, for example XMega128A1, or long programming cables some errors maybe raised. Here Atmel recommends that the clock rate of the PDI interface should be reduced. This can be done in “Options/Programmer options“. 48 · Addenum XMega E-LAB Computers
UPP1-X In-Circuit Programmer with USB-2 TINY4-5-9-10-20 These Tinys must be programmed with 5V through 3 pins. The programming mode is called TPI. Because the same programming plug is also used by the SPI mode the plug on the target system differs from the Atmel plug. The load on the TPI_DAT pin must not be lower than 80kOhm. This is the connection of the programmer cable to a TPI Tiny. Because the RESET pin of these TINYs can be disabled by a fuse a normal re-programming of these devices is not possible. Then the high-voltage programming mode must be used. Fortunately the programming scheme is the same but only the RESET line must be set to 12V. Here is a simple schematic where the RESET output of the programmer is used to switch a 12V source: E-LAB Computers Addendum Tiny 4, 5, 9, 10, 20 · 49
Page 1 and 2: User Manual E-LAB UPP1-X Programmer
Page 3 and 4: UPP1-X In-Circuit Programmer with U
Page 5 and 6: CONNECTIONS UPP1-X In-Circuit Progr
Page 27 and 28: Project download UPP1-X In-Circuit
Page 45 and 46: USB DRIVERS Windows compatibility U
Page 47: UPP1-X In-Circuit Programmer with U
Page 57 and 58: Notes
Page 59 and 60: Notes

Manual - E-LAB Computers

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?