Download - Buderus

More documents

Recommendations

Info

Contents 13 Appendix 52 13.1 Operating messages 52 13.2 Error messages 53 13.3 Technical specifications 54 14 Reports 56 14.1 Start-up report 56 14.2 Inspection report 57 14.3 Maintenance report 58 15 Spare parts 59 16 Index 63 4 Logamax plus GB142-24/30/45/60 - We reserve the right to make any changes due to technical modifications!
Safety and general instructions 1 1 Safety and general instructions Please observe these instructions in the interest of your own safety. 1.1 Designated use The boiler was designed for heating water for a central heating system and generating domestic hot water. The boiler is delivered with a BC10 basic controller and the "Universal Automatic Burner Control Unit 3" (UBA 3) pre-installed. The boiler can be fitted with a modulating outdoor reset control AM10 (scope of delivery), a room controller RC10 (optional), or an On/Off thermostat or relay panel end switch (accessories). 1.2 Hazard definitions The following defined terms are used throughout the documentation to bring attention to the presence of hazards of various risk levels. Notices give important information concerning the operation of the product. DANGER: Indicates the presence of hazards that will cause severe personal injury, death or substantial property damage. WARNING: Indicates the presence of hazards that can cause severe personal injury, death or substantial property damage. CAUTION: Indicates presence of hazards that will or cause minor personal injury or property damage. CAUTION: Risk of electric shock. Indicates presence of hazards due to electric shock. NOTICE: Indicates special instructions on installation, operation or maintenance that are important but not related to personal injury or property damage. 1.3 The following instructions must be observed – The boiler must only be used for its designated purpose, observing the Installation Instructions. – Only use the boiler in the combinations and with the accessories and spares listed. – Other combinations, accessories and consumables must only be used if they are specifically designed for the intended application and do not affect the system performance and the safety requirements. – Maintenance and repairs must only be carried out by trained professionals. – You must report the installation of a condensing gas boiler to the relevant gas utility company and have it approved. – You are only allowed to operate the condensing gas boiler with the combustion air/flue gas system that has been specifically designed and approved for this type of boiler. – Please note that local permission for the flue system and the condensate water connection to the public sewer system may be required. You must also observe: – the local building regulations stipulating the installation rules. – the local building regulations concerning the air intake and outlet systems and the chimney connection. – the regulations for the power supply connection. – the technical rules laid down by the gas utility company concerning the connection of the gas burner fitting to the local gas main. – the instructions and standards concerning the safety equipment for the water/space heating system. – the Installation Instructions for building heating systems. – The boiler must be located in an area where leakage of the tank or connections will not result in damage to the area adjacent to the boiler or to lower floors of the structure. When such locations cannot be avoided, it is recommended that a suitable drain pan, adequately drained, be installed under the boiler. The pan must not restrict combustion air flow. – The boiler must be installed such that the gas ignition system components are protected from water (dripping, spraying, rain etc.) during boiler operation and service. – The boiler must not be installed on carpeting. – Do not restrict or seal any air intake or outlet openings. – If you find any defects, you must inform the owner of the system of the defect and the associated hazard in writing. Logamax plus GB142-24/30/45/60 - We reserve the right to make any changes due to technical modifications! 5
Page 1 and 2: Installation instructions Condensin
Page 3: Contents 1 Safety and general instr
Page 7 and 8: Regulations and guidelines 2 2 Regu
Page 9 and 10: Product description 3 3 Product des
Page 11 and 12: Dimensions and connections 4 20" (5
Page 13 and 14: Installation 6 6 Installation 6.1 R
Page 15 and 16: Installation 6 Steel pipe Equivalen
Page 17 and 18: Installation 6 WARNING FLUE GAS AIR
Page 19 and 20: Installation 6 DANGER: FIRE DANGER
Page 21 and 22: Installation 6 6.7 Installation of
Page 23 and 24: Installation 6 5' (1525 mm) 7' (213
Page 25 and 26: Installation 6 10"- 0" MIN (250 mm
Page 27 and 28: Electrical connections 7 7 Electric
Page 29 and 30: 1 4 5 Electrical connections 7 CAUT
Page 31 and 32: Start-up procedure 8 8.1 Testing fo
Page 33 and 34: Start-up procedure 8 8.6 Checking t
Page 35 and 36: Start-up procedure 8 • Switch on
Page 37 and 38: Start-up procedure 8 8.12 Measuring
Page 39 and 40: BC10 basic controller 9 9 BC10 basi
Page 41 and 42: BC10 basic controller 9 Displays (e
Page 43 and 44: BC10 basic controller 9 • Turn th
Page 45 and 46: BC10 basic controller 9 9.3.4 Setti
Page 47 and 48: Inspection 11 11 Inspection We advi
Page 49 and 50: Maintenance 12 12 Maintenance CAUTI
Page 51 and 52: Maintenance 12 • Switch off the h
Page 53 and 54: Appendix 13 13.2 Error messages •
Page 55 and 56:
Appendix 13 Type of gas supply Fact
Page 57 and 58:
Reports 14 14.2 Inspection report
Page 59 and 60:
Spare parts 15 15 Spare parts Below
Page 61 and 62:
Spare parts 15 Exploded view Logama
Page 63 and 64:
Index 16 16 Index B Baffle plate .
show all

Download - Buderus

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?