NV52/NV54/NV56/NV58 Service Guide - tim.id.au
NV52/NV54/NV56/NV58 Service Guide - tim.id.au
NV52/NV54/NV56/NV58 Service Guide - tim.id.au
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
60<br />
CHAPTER 3: Replacing notebook components<br />
Replacing the mul<strong>tim</strong>edia board<br />
Tools you need to complete this task:<br />
Phillips #0 screwdriver<br />
Flat screwdriver or Non-marring plastic scribe<br />
Screws removed during this task:<br />
• 3 black M2.5×6 (keyboard cover)<br />
To replace the mul<strong>tim</strong>edia board:<br />
1 Complete the steps in “Preparing the notebook” on page 47.<br />
2 Remove the keyboard cover by performing steps 2–6 of the “Replacing the<br />
keyboard cover” procedure on page 58.<br />
C<strong>au</strong>tion<br />
The mul<strong>tim</strong>edia board is glued to the keyboard cover. Remove this<br />
board only if it is defective.<br />
3 Insert a small flat-blade screwdriver or non-marring scribe between the<br />
mul<strong>tim</strong>edia board and the keyboard cover’s unders<strong>id</strong>e, and carefully pry the<br />
board loose.<br />
4 Remove the mul<strong>tim</strong>edia board from the keyboard cover.<br />
Note<br />
A circuit board that is >10 cm 2 has been highlighted with a yellow<br />
rectangle as shown in the above image. Follow the local regulations<br />
for disposing this type of circuit board.
Change language