NV52/NV54/NV56/NV58 Service Guide - tim.id.au
NV52/NV54/NV56/NV58 Service Guide - tim.id.au
NV52/NV54/NV56/NV58 Service Guide - tim.id.au
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
www.gateway.com<br />
16 Locate the small gaps on the top s<strong>id</strong>e of the palm rest and insert a small<br />
flat-blade screwdriver or non-marring scribe into each gap to separate the<br />
palm rest from the base enclosure.<br />
17 Once the top s<strong>id</strong>e is separated, pry loose the left and right s<strong>id</strong>es of the palm<br />
rest, and finally the bottom s<strong>id</strong>e until all the palm rest retaining tabs have<br />
been released.<br />
18 Lift the palm rest assembly from the base enclosure.<br />
19 Place the new palm rest assembly on top of the base enclosure and press<br />
it down on all s<strong>id</strong>es until it snaps into place.<br />
20 Reconnect the speaker, mul<strong>tim</strong>edia, and touchpad cables to their respective<br />
system board connectors.<br />
21 Secure the palm rest assembly with the screws removed in steps 13 and 15.<br />
22 Reinstall the LCD panel assembly by performing steps 16–23 of the<br />
“Replacing the LCD panel assembly” procedure on page 64.<br />
23 Reinstall the keyboard and the keyboard cover by performing steps 5–8 of<br />
the “Replacing the keyboard” procedure on page 62.<br />
24 Return the optical screw drive in its place.<br />
25 Reinstall the hard drive by performing steps 8 and 9 of the “Replacing the<br />
hard drive” procedure on page 54.<br />
26 If you have disconnected any wireless antennas, reconnect them now.<br />
27 Reinstall the bay cover.<br />
71
Change language