Panasonic 2-Line 2.4GHz MultiTalk Expandable - Radio Shack

Answering System
Problem
The Answering System is
on, but incoming messages
are not recorded.
“ ALL MAILBOX FULL ” is displayed
and the ANSWER ON
indicator flashes rapidly,
and no new messages are
recorded.
You cannot access a
mailbox from the base unit
or the handset.
You cannot access a
mailbox from a touch tone
phone.
Cause & Remedy
•The recording time is set to “Greeting only”. Select
“1 minute”, “2 minutes” or “3 minutes” (p. 27).
•Memory is full. Erase some, or all, of the
messages (p. 88).
•Memory is full. Erase some, or all, of the
messages (p. 88).
•If more than one other user is using the
handsets and base unit, you may not be able
to access the mailboxes. Try again later.
•If 2 other users are listening to messages in
the mailboxes, you cannot access a mailbox.
Try again later.
•If the Answering System is responding to a
call and another user is listening to messages
in a mailbox, you cannot access a mailbox.
Try again later.
•Your handset is too far from the base unit.
Walk closer to the base unit.
•Make sure you enter the correct remote code
(p. 95).
•If “Enter Mailbox password” is heard, Mailbox 2 or
3 has the password. Enter the password (p. 83).
•The Answering System may not respond if
the tones are too short to activate the unit.
Press each button firmly.
•The Answering System is off. Turn it on (p. 98).
While recording a greeting
message, the unit starts to
ring and stops recording.
During playback, incoming
call tones are heard.
•To answer the call, press
(DIGITAL!SP-PHONE) or the line button. Start
again from the beginning after hanging up.
•To answer the call, if you are using the base
unit, press the called line button. If you are
using the handset, press the relevant soft key
( LINE1 or LINE2 ). For playback, start again
from the beginning after hanging up.
Useful Information
For assistance, please call: 1-800-211-PANA(7262)
111