TM 3-4240-334-20&P
TM 3-4240-334-20&P
TM 3-4240-334-20&P
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>TM</strong> 3-<strong>4240</strong>-<strong>334</strong>-20&P<br />
2-13. MASK ASSEMBLY ADJUS<strong>TM</strong>ENT, INSPECTION, AND REPAIR.<br />
This task covers:<br />
a. Facepiece Hood Repair h.<br />
b. Eye Lens Cushion Replacement<br />
c. Internal Drink Tube Replacement i.<br />
d. Outlet Valve Disk Replacement j.<br />
e. Outlet Valve Cover Replacement k.<br />
f. Voicemitter Replacement l.<br />
g. Linear Microphone and Microphone<br />
Adapter Replacement (Type I Mask)<br />
Dynamic Microphone and Microphone Adapter<br />
Replacement (Type II Mask)<br />
Setscrew Adjustment and Replacement<br />
Canister Inspection and Replacement<br />
Flat Washer Replacement<br />
Mask Carrier Strap Replacement<br />
a. Facepiece Hood Repair.<br />
INITIAL SETUP<br />
Materials/Parts<br />
Maintenance Kit, Toxicological Agent<br />
Protective Clothing (Item 17, App D)<br />
Cloth (Item 8, App D)<br />
Equipment Condition<br />
Canister disconnect detached from blower<br />
NOTE<br />
Hood repair procedures include the following restrictions.<br />
1. Do not attempt to repair facepiece hood if it is separated from faceblank. Replace facepiece assembly.<br />
2. Do not apply more than three patches per hood.<br />
3. Do not overlap patches.<br />
4. Do not repair hood if:<br />
REPAIR<br />
2-48<br />
(a) Tears are longer than 1 inch<br />
(b) Holes are larger than 1 inch in diameter<br />
(c) Tears or holes are less than 2 inches apart<br />
(d) Tears or holes are on strapped seams<br />
(e) Tears or holes are within 2 inches of faceblank<br />
CAUTION<br />
When performing maintenance on the mask, do not scratch the plastic lenses.<br />
Keep work area clean. Dirt in or on items could prevent airtight integrity.<br />
1. Locate chafed, torn, or punctured area on hood.<br />
2. Clean and dry damaged area with dry cloth.<br />
3. Buff area lightly but thoroughly with abrasive strip (1).