TM 3-4240-334-20&P

More documents

Recommendations

Info

TM 3-4240-334-20&P 2-16. HARNESS ASSEMBLY LANYARD REPLACEMENT. This task covers: Removal and Installation of Lanyard INITIAL SETUP Tools None. REMOVAL 1. Unfasten clips (1) on harness assembly (2). 2. Slide Ianyard with attached loops (3) off of harness assembly. INSTALLATION Slide lanyard (3) onto harness assembly (2). 2-70
TM 3-4240-334-20&P Section VII. PREPARATION FOR STORAGE OR SHIPMENT 2-17. GENERAL. This section contains storage and shipping information for the M43A1 mask. The storage information is divided into two areas: Temporary Storage less than 30 days or Extended Storage more than 30 days. 2-18. PREPARATION FOR STORAGE OR SHIPMENT. CAUTION Store mask in a dry place. Moisture may damage the mask components. NOTE Anytime the mask is stored for over 30 days, insert the faceform into the facepiece to prevent distortion of the faceblank. a. Temporary Storage Less Than 30 Days. (1) Store faceform according to unit SOP. (2) Stow mask and accessories in carrier as described in Operator's Manual, TM 3-4240-334-10. (3) Hang the carrier by the shoulder strap. (4) Make sure storage temperatures remain between -25°F and + 125°F (-31 .7°C and + 51.7°C). b. Extended Storage (30 Days or More). (1) (2) (3) (4) Remove batteries from primary blower and auxiliary blower and store separately. Insert faceform into facepiece to prevent distortion. Stow mask and accessories in original foam in shipping carton. Make sure storage temperatures remain between -60°F and + 160°F (-51.1°C and + 71.1°C). c. Shipment. Remove batteries from blower and auxiliary blower. Use box, lid, and internal packaging retained in Service Upon Receipt of Materiel, para 2-5. 2-71
Page 1 and 2:
TM 3-4240-334-20&P UNIT MAINTENANCE
Page 3 and 4:
TM 3-4240-334-20&P WARNING Wear a p
Page 5 and 6:
TM 3-4240-334-20&P TABLE OF CONTENT
Page 7 and 8:
TM 3-4240-334-20&P M43A1 MASK 1-0
Page 9 and 10:
TM 3-4240-334-20&P 1.7. CORROSION P
Page 11 and 12:
TM 3-4240-334-20&P CHAPTER 2 MAINTE
Page 13 and 14:
TM 3-4240-334-20&P NOTE IPD staples
Page 15 and 16:
TM 3-4240-334-20&P CHECKING UNPACKE
Page 17 and 18:
TM 3-4240-334-20&P Section III. EQU
Page 19 and 20:
TM 3-4240-334-20&P (d) Check that f
Page 21 and 22:
TM 3-4240-334-20&P (l) Remove test
Page 23 and 24:
TM 3-4240-334-20&P 2-8. MASK ASSEMB
Page 25 and 26:
TM 3-4240-334-20&P Section IV. PREV
Page 27 and 28:
TM 3-4240-334-20&P Item No. Interva
Page 29 and 30: TM 3-4240-334-20&P Item No. Interva
Page 37 and 38: TM 3-4240-334-20&P Item No. lnterva
Page 41 and 42: TM 3-4240-334-20&P Interval Item to
Page 47 and 48: TM 3-4240-334-20&P para 2-8 TM-3-42
Page 49 and 50: TM 3-4240-334-20&P Table 2-3. Troub
Page 51 and 52: TM 3-4240-334-20&P para 2-13 2-41
Page 53 and 54: TM 3-4240-334-20&P 2-43
Page 55 and 56: TM 3-4240-334-20&P Table 2-6. Troub
Page 57 and 58: TM 3-4240-334-20&P Section VI. MAIN
Page 59 and 60: TM 3-4240-334-20&P NOTE Buffed area
Page 61 and 62: TM 3-4240-334-20&P c. Internal Drin
Page 63 and 64: TM 3-4240-334-20&P e. Voicemitter R
Page 65 and 66: TM 3-4240-334-20&P g. Linear Microp
Page 67 and 68: TM 3-4240-334-20&P h. Dynamic Micro
Page 69 and 70: TM 3-4240-334-20&P l. SETSCREW ADJU
Page 71 and 72: TM 3-4240-334-20&P k. Flat Washer R
Page 73 and 74: TM 3-4240-334-20&P 2-14. BLOWER ASS
Page 75 and 76: TM 3-4240-334-20&P c. Webbing Strap
Page 77 and 78: TM 3-4240-334-20&P 2-15. AUXILIARY
Page 79: TM 3-4240-334-20&P c. Canister Seal
Page 83 and 84: TM 3-4240-334-20&P (5) Air dry for
Page 85 and 86: TM 3-4240-334-20&P A-5. MISCELLANEO
Page 87 and 88: TM 3-4240-334-20&P B-2. MAINTENANCE
Page 89 and 90: TM 3-4240-334-20&P Section II. MAIN
Page 91 and 92: TM 3-4240-334-20&P APPENDIX C UNIT
Page 93 and 94: TM 3-4240-334-20&P AO-(Assembled by
Page 95 and 96: TM 3-4240-334-20&P e. DESCRIPTION A
Page 97 and 98: TM 3-4240-334-20&P C-6. HOW TO LOCA
Page 99 and 100: SECTION II TM3-4240-334-20&P (1) (2
Page 123 and 124: SECTION IV TM3-4240-334-20&P CROSS-
Page 125 and 126: SECTION IV TM3-4240-334-20&P CROSS-
Page 127 and 128: TM 3-4240-334-20&P APPENDIX D EXPEN
Page 129 and 130: TM3-4240-334-20&P SECTION II.EXPEND
Page 131 and 132:
TM 3-4240-334-20&P Subject F (CONT)
Page 133 and 134:
TM 3-4240-334-20&P Subject Page Uni
Page 138:
PIN: 069616-000
show all

TM 3-4240-334-20&P

Create successful ePaper yourself

Delete template?

Save as template?