JAEA-Data/Code 2007-004 - Welcome to Research Group for ...

============= Section 005 : Zone placement =============
Card-005-1 Input section name (I3)
Enter ‘005’.
Card-005-2
(24I3)
Allocate the zone identification numbers of each vertical region. The order of
input is for the first horizontal row of regions going from left to right. For a
one-dimensional problem the zone numbers are specified for only horizontal
regions.
For 2-D problem, beginning with a new card, specify the zone numbers of each
vertical region in the second horizontal row of regions. Continue these
specifications going from top to bottom.
A sample input for Card-005 is as follows:
---------+---------+---------+---------+-----
005
2 2 2
2 1 2
2 2 2
---------+---------+---------+---------+-----
For a three-dimensional problem, give the two-dimensional grid for each block
of mesh-point planes going from front to back.
============= Section 006 : Mesh overlay =============
New zones may be superimposed within a mesh described with this data. But the input of this
section is not necessarily required. Zone number allocation by region given by 005 section is internally
replaced by code into zone number allocation by mesh. This zone allocation by mesh can be replaced
with this data.
e.g. if a map of a core with the control rod withdrawn is described by 005 section, zone number
of the meshes where the control rod is inserted can be modified by using 006 section. Thus, fine
position of control rod insertion can be specified.
Card-006-1 Input section name (I3)
Enter ‘006’.
Card-006-2 Zone number (I3)
Repeat Card-006-2 and Card-006-3 until zero zone number (blank card) is
encountered.
110