JAEA-Data/Code 2007-004 - Welcome to Research Group for ...

= 2 Normalized values
= 3 None
38 I6 Indicator to prepare and print coarse-mesh balance tables
= 0 Yes
= 1 No
Note:
The tables are for the rebalance mesh when the rebalance mesh and material
mesh are different. (always same in the SRAC)
The preparation of these tables requires an additional outer iteration after
problem convergence.
39 IANG Edit for angular fluxes. The preparation of angular fluxes requires an additional
outer iteration after problem convergence as well as additional storage.
= -1 Print and store on logical device 8
= 0 None
= 1 Store on logical device 8
40 IMC Number of material coarse-mesh intervals in the i-direction.
= 0 (suppressed)
Note:
When this value is non-zero, the rebalance coarse-mesh as given by items IM
and JM is not the same as the material coarse-mesh. The material coarse-mesh is
the same as the mesh upon which all edits are done. When edits are requested and
IMC is not zero, angular fluxes must be stored. See entries IDCS, XM, IHXC, and
XRAD below.
41 JMC Number of material coarse-mesh intervals in the j-direction.
= 0 (suppressed)
42 IF0 Interface file output is created. Total (angle-integrated) flux on ITFLUX (=33) and
angular weight constants on ISNCONS(=11) files are always created. Angular flux
file is created on LAFLUX (=9) only if IANG is not zero.
= 0 No
82