JAEA-Data/Code 2007-004 - Welcome to Research Group for ...

3 U238 The position of the second nuclide in the same material. Count the position in the
order of material specification.
4 IX Mesh number of X-direction where the neutron spectrum is obtained. Enter
R-Region number for the collision probability calculation as it can be assumed as
one-dimensional calculation.
5 IY Mesh number of Y-direction where the neutron spectrum is obtained.
Enter IY=0 for one-dimensional calculation.
6 IZ Mesh number of Z-direction where the neutron spectrum is obtained. Enter IZ=0
for one- and two-dimensional calculations.
(FGS (g),g=1,IGMAX)
Filter transmission by energy group(g), where 0 ≤ f g ≤ 1. They are applied in
Eqs.(2.10-9) and (2.10-10). IGMAX is number of energy groups (IGMAX=NEF+
NET for fine group calculation and IGMAX=NERF+NERT for few group one, cf.
Sect.2.2)
Repeat Block-4-1 IOPT(3) times.
--------------------------------------------------------------------------------------------------------------------------
Block-5-1 Required if IOPT(4)>0 and after CITATION calculation /1/
NZONE Number of zones used in CITATION calculation (=NM of Block-1 in Sect.2.8)
Block-5-2 Required if IOPT(4)>0 and after CITATION calculation /A8/
MTNAME(i) Material name of the detector assigned to zone i.
The member of this name must be prepared on MACRO or MACROWRK file.
The fifth character (e-tag) and the eighth one (p-tag) may be arbitrary as they are
specified by the code (cf. Sect.2.9).
If a blank material name is entered, the corresponding zone is excluded from the
integration.
Repeat Block-5-2 NZONE times.
Block-5-3 Required if IOPT(4)>0 and after CITATION calculation /2/
133