JAEA-Data/Code 2007-004 - Welcome to Research Group for ...

2 NFX2 Optional print control
= 0 No print out of fixed source
> 0 Print out of fixed source
Card-026-3 Required if NFX1 ≤ 0 (6E12.5)
KMAX entries of relative values of source spectrum. Normalization to unity is not
necessary. In this case, the KMAX value in Card-008-2 must be proper.
Card-026-4 Required if NFX1=0 (6I4,E12.5)
Specify blocks of points by left column number and then right column number
to give limits along rows, top and bottom row numbers for column limits, and front
and back plane numbers for depth limits in that order. If only one row is involved,
for example, then that row is repeated as limits. Only 4 entries among 6 are valid
for each specification in 2-D geometry. Data is read until zero value is encountered
on the first column number. The entry ‘000600060005001500020002’ defines the
spatial range along column 6 from row 5 through 15 and on plane 2 only.
1 JL Left column number
2 JR Right column number
3 IT Top raw number
4 IB Bottom raw number
5 KBF Front plane number
6 BB Back plane number
7 X = 0.0 Give spatial distribution by Card-026-5
> 0.0 Use this value as a source intensity (n/sec-cm 3 ) over the spatial range
specified above
Card-026-5 Required if NFX1=0 and X=0.0 (6E12.5)
Enter fine distribution of source intensity (n/sec/cm 3 ) in the range specified by
Card-026-4 starting with the value at the left limit JL to the right limit JR on the
horizontal raw IT, then those on the second raw until the raw limit IB on the plane
KBF are met. Then data are required by beginning a new card for the second plane.
The total number of entries is (JR-JL+1)*(IB-IT+1)*(KBB-KBF+1).
Repeat Card-026-4 and Card-026-5 until a blank Card-026-4 is encountered.
115