F-1⢠Installation Manual - Viking Access
F-1⢠Installation Manual - Viking Access
F-1⢠Installation Manual - Viking Access
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
GATE OPERATOR INSTALLATION<br />
Step 4<br />
Upon observation of the satisfactory<br />
arrangement of the articulated arm and<br />
bracket, weld all pieces securely. Paint the<br />
arm to protect it from rusting.<br />
STEP 5<br />
Upon test of the installation, loosen the<br />
clutch and rotate it until it lines up with the<br />
notches in the Output Shaft. Insert the<br />
Clutch Key.<br />
Insert<br />
Clutch Key<br />
STEP 6<br />
Check the Clutch adjustment. The Clutch is<br />
shipped factory adjusted. The clutch must be<br />
tight enough to prevent slippage in normal<br />
operation.<br />
Check the tightness of the Clutch:<br />
A. Remove the Clutch Key from the clutch.<br />
B. Attempt to move the gate by hand.<br />
C. If slippage occurs:<br />
1. Loosen the Locking Handle 180°<br />
2. Tighten the opposite bolt.<br />
3. Tighten the Locking Handle 180°<br />
4. Check the tightness of the clutch again.<br />
Tighten the Clutch<br />
Adjust the<br />
Opposite Bolt<br />
NOTE – For proper operation of the Clutch,<br />
keep the gap between the Clutch halves<br />
even when adjusting (the Clutch will have<br />
to be removed from the Output Shaft in<br />
order to adjust the Release Handle bolt).<br />
17<br />
TECHNICAL SUPPORT 1 800 908 0884 13
Change language