Curlin 2000 User Manual - Med-E-Quip Locators

There are two AC Adapters:
AC Adapters
• The US Domestic AC Adapter has a three-prong plug to be plugged into a standard
three-prong, grounded wall receptacle and a six-foot cable which plugs into the power
outlet on the bottom of the pump.
• The Universal AC Adapter available for international use.
This accessory becomes the external power source when plugged directly into the Curlin
Medical pump (see Figure 1.2 for external power port location on the bottom of the pump).
The AC Adapter can also be used to recharge the portable battery pack by plugging the
connecting cable into the recharging port on the battery pack (see Figure 1.12). The two-pin
connector on the end of the cable plugs into the receptacles correctly by aligning the red dots on
each.
Note: Pause the pump and then turn it off before connecting the AC Adapter. Note, also that
the connector is keyed with a “notch” at this red-dot location to guide alignment. To
remove, pull back on the locking sleeve to unlock and then pull gently to remove the
connector from the battery pack or pump’s port.
US Domestic AC Adapter
Universal AC Adapter
Locking Sleeve
Locking Sleeve
Two-Pin Adapter plugs into port on bottom of the
pump for AC power or can be used to recharge the
battery pack by plugging into the recharging port
on the battery pack (see Figure 1.12). Note the
connector notched keying and red dot alignment.
To remove, pull back on the locking sleeve.
Figure 1.13 AC Adapters
20