Models and Parameters - Digitech

More documents

Recommendations

Info

14 Mixer 1 2 3 4 5 6 Stereo Mixer Setup Outputs Amp/Mixer switch set to Mixer Instrument Input Powered Studio Monitor Computer Recording Setup USB Outputs Amp/Mixer switch set to Mixer Powered Studio Monitor Instrument Input
Applying Power Before applying power to anything, set your amp(s) to a clean tone and set the tone controls to a flat EQ response (on most amps, this would be 0 or 5 on the tone controls). Then follow the steps listed below. 1. Turn the amp volume all the way down. 2. Connect the plug of the PS0913B power supply to the power jack on the rear panel of the RP250. 3. Connect the other end of the PS0913B power supply to an AC outlet. Turn the RP250’s Master Level knob (Knob 4) down to “0”. 4. Turn the power of your amplifier(s) to the on position and adjust the volume(s) to a normal playing level. 5. Gradually increase the RP250’s Master Level knob to achieve the desired volume. 4. Turn amp volume up 1. Turn amp volume down 2. Connect PS0913B to power jack 3. Connect PS0913B to AC outlet and turn the RP250’s Master Level to “0” 5. Turn the RP250’s Master Level to the desired listening volume 15
Page 1: Modeling Guitar Processor User’s
Page 4 and 5: Table of Contents Section One - Int
Page 6 and 7: Warranty We at DigiTech ® are very
Page 8 and 9: 2 About the RP250 Performance Mode
Page 10 and 11: 4 Tone Library (Knob 1) In Performa
Page 12 and 13: 6 A Guided Tour of the RP250 Front
Page 14 and 15: 8 Effects Level (Knob 3) 1. In Perf
Page 16 and 17: 10 Rear Panel 1. Input Connect your
Page 18 and 19: 12 Getting Started Making Connectio
Page 22 and 23: 16 Section Two - Editing Functions
Page 24 and 25: 4. Select the User preset location
Page 26 and 27: 20 Model Definitions Each Amp and E
Page 28 and 29: 22 scream - Based on an Ibanez ® T
Page 30 and 31: 24 57chmp - Based on a ‘57 Fender
Page 32 and 33: EQ The RP250’s EQ helps further s
Page 34 and 35: 28 from 0 to 99. Waveform (X-Edit T
Page 36 and 37: VibroPan (vibpan) A vibrato is an e
Page 38 and 39: 32 Range - Knob 4 adjusts the throa
Page 40 and 41: 34 Intelligent Pitch Shifting (IPS)
Page 42 and 43: 36 Duck Thresh (X-Edit TM only) - A
Page 44 and 45: 38 Section Four - Other Functions D
Page 46 and 47: 40 Factory Reset This function rese
Page 48 and 49: 42 Section 5 - Appendix Specificati
Page 50: 44 Expression Pedal - Assignable Pa
Page 53 and 54: Effects Library 47
Page 56: DigiTech® 8760 South Sandy Parkway

Models and Parameters - Digitech

Create successful ePaper yourself

Delete template?

Save as template?