Models and Parameters - Digitech

More documents

Recommendations

Info

28 from 0 to 99. Waveform (X-Edit TM only for DigiTech Chorus models) - Selects a waveform: triang, Sine, or Square. Flanger A Flanger uses the same principle as a Chorus but uses a shorter delay time and adds regeneration (or repeats) to the modulating delay. This results in an exaggerated up and down sweeping motion to the effect. The RP250 includes the following Flanger Effect models: fLangr (the DigiTech Flanger), and mxFLgr (based on an MXR ® Flanger). Knobs 2, 3, and 4 have the following functions for the Flanger models: Flanger Model Knob 2 (Speed) Knob 3 (Depth) Knob 4 (Regen) P5 (X-Edit TM only) P6 (X-Edit only) flangr Speed Depth Regen Waveform Level mxflgr Speed Width Regen Manual -- Phaser (PHaser) A phaser splits the incoming signal, and then changes the phasing of the signal. This signal is then taken in and out of phase and mixed back in with the original signal. As the phasing changes, different frequencies get canceled resulting in a warm sort of twisting sound. Knobs 2, 3, and 4 have the following functions for the two Phaser models: Speed - Knob 2 adjusts the rate (Speed) of the modulation. Ranges from 0 to 99.
Depth - Knob 3 adjusts the Depth of the modulation. Ranges from 0 to 99. Regeneration - Knob 4 controls the regeneration of the effect. Ranges from 0 to 99. Waveform (X-Edit TM only) - Selects a waveform: triang, Sine, or Square. Level (X-Edit only) - Controls the level of the effect. Ranges from 0 to 99. Vibrato (viBrat) A Vibrato effect modulates the pitch of the incoming signal at an even rate. Speed - Knob 2 adjusts the rate (Speed) at which the pitch modulates. Ranges from 0 to 99. Depth - Knob 3 adjusts the intensity (Depth) of the modulating pitch. Ranges from 0 to 99. Rotary Speaker (rOtArY) Rotary Speaker is an emulation of a device that included a spinning horn and woofer. The rotation of these two speakers produced an interesting combination of the sound panning from side to side. This produced a slight pitch change due to the speed of the sound coming towards, and then going away from the listener. Speed- Knob 2 adjusts the rate (Speed) of the spinning speakers. Ranges from 0 to 99. Intensity - Knob 3 controls the intensity of the effect. Ranges from 0 to 99. Doppler - Knob 4 controls the Pitch Shift effect that is the ratio between the horn and the rotor positions. Ranges from 0 to 99. Crossover (X-EditTM only)- Selects the crossover frequency between the horn and rotor. Ranges from 0 (200 Hz) to 99 (1600 Hz). 29
Page 1: Modeling Guitar Processor User’s
Page 4 and 5: Table of Contents Section One - Int
Page 6 and 7: Warranty We at DigiTech ® are very
Page 8 and 9: 2 About the RP250 Performance Mode
Page 10 and 11: 4 Tone Library (Knob 1) In Performa
Page 12 and 13: 6 A Guided Tour of the RP250 Front
Page 14 and 15: 8 Effects Level (Knob 3) 1. In Perf
Page 16 and 17: 10 Rear Panel 1. Input Connect your
Page 18 and 19: 12 Getting Started Making Connectio
Page 20 and 21: 14 Mixer 1 2 3 4 5 6 Stereo Mixer S
Page 22 and 23: 16 Section Two - Editing Functions
Page 24 and 25: 4. Select the User preset location
Page 26 and 27: 20 Model Definitions Each Amp and E
Page 28 and 29: 22 scream - Based on an Ibanez ® T
Page 30 and 31: 24 57chmp - Based on a ‘57 Fender
Page 32 and 33: EQ The RP250’s EQ helps further s
Page 36 and 37: VibroPan (vibpan) A vibrato is an e
Page 38 and 39: 32 Range - Knob 4 adjusts the throa
Page 40 and 41: 34 Intelligent Pitch Shifting (IPS)
Page 42 and 43: 36 Duck Thresh (X-Edit TM only) - A
Page 44 and 45: 38 Section Four - Other Functions D
Page 46 and 47: 40 Factory Reset This function rese
Page 48 and 49: 42 Section 5 - Appendix Specificati
Page 50: 44 Expression Pedal - Assignable Pa
Page 53 and 54: Effects Library 47
Page 56: DigiTech® 8760 South Sandy Parkway

Models and Parameters - Digitech

Create successful ePaper yourself

Delete template?

Save as template?