iSTAR Pro 4U Rack Mount Quick Start Installation Guide

More documents

Recommendations

Info

Components/Connections Input from ACM Relay CDX Jumpers for Output Mode DIP Switch set for Negative Trip Do not change Power Source is present Power Jumpers Do not change Door Outputs NO = Relay NO C = Relay Common NC = Relay NC COM = Voltage Common LED indicating Output is active LED indicating no F/A when lit Power IN FIGURE 15. APD8 Layout 22
Components/Connections FIGURE 16. CDX Jumper TABLE 9. Troubleshooting Condition Possible Cause Solution No power on output(s) Output not dropping power on a FA input J1 and J2 set incorrectly No power input Zone Input in the wrong state Zone Output wired incorrectly Output Configuration Jumper set incorrectly Blown Fuse / Tripped PTC FACP Input active Other <strong>Pro</strong>blem Output Configuration Jumper set incorrectly FACP Input wired incorrectly Zone Output wired incorrectly Both jumpers should be in. Verify power is present on the power input terminals. If J1 and J2 are removed, BOTH power inputs must be powered. Verify the input is configured properly Verify the output is configured properly See Figure 16 Verify output integrity and replace fuse, or remove output load to reset PTC. Verify that the FACP input is not activated. Contact AlarmSaf See Figure 16 Verify the FACP Input configuration Verify the Zone Output wiring 23
Page 1 and 2: iSTAR Pro 4U Rack Mount Quick Start
Page 3 and 4: Features System Components The iSTA
Page 5 and 6: Features Mounting Instructions, 4 P
Page 7 and 8: Features Part Numbers TABLE 1. iSTA
Page 9 and 10: Specifications TABLE 5. Electrical
Page 11 and 12: COMPONENTS/ CONNECTIONS Front Panel
Page 13 and 14: Components/Connections Rear Connect
Page 15 and 16: Components/Connections Bottom Row R
Page 17 and 18: Components/Connections After wiring
Page 19 and 20: Components/Connections AC IN Indica
Page 21: Components/Connections APD8 Boards
Page 25 and 26: Components/Connections Lock Power V
Page 27 and 28: Components/Connections Maglock RM R
Page 29 and 30: Components/Connections Fail Safe/Fa
Page 31 and 32: Cable Distances and Power Following
Page 33 and 34: Cable Distances and Power NO and NC
Page 35 and 36: GCM General Control Module GCM GENE
Page 37 and 38: GCM General Control Module GCM Diag
Page 39 and 40: GCM General Control Module GCM Batt
Page 41 and 42: ACM - Access Control Module(s) ACM
Page 43 and 44: ACM - Access Control Module(s) LEDs
Page 45 and 46: ACM - Access Control Module(s) 1 Wi
Page 47 and 48: ACM - Access Control Module(s) In t
Page 49: ACM - Access Control Module(s) C•

iSTAR Pro 4U Rack Mount Quick Start Installation Guide

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?