iSTAR Pro 4U Rack Mount Quick Start Installation Guide
iSTAR Pro 4U Rack Mount Quick Start Installation Guide
iSTAR Pro 4U Rack Mount Quick Start Installation Guide
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
GCM General Control Module<br />
S4 Restricted Switches<br />
S4 positions 1 through 4:<br />
• Are reserved for <strong>iSTAR</strong> <strong>Pro</strong> features<br />
• Activate diagnostic or repair operations for use by Technical Support<br />
representatives.<br />
TABLE 15. S4 Restricted Switches<br />
Switch Setting<br />
Position 1 Position 2 Position 3 Position 4<br />
Description<br />
On On or Off On or Off On or Off Reserved. Do not set position 1 to Off unless specifically<br />
instructed to do so by Customer Support.<br />
Off Off Off Off Normal operation.<br />
Off On Off Off Clears on board DIMM memory and data on flash memory.<br />
Note:<br />
This switch resets the <strong>iSTAR</strong> <strong>Pro</strong> to the factory<br />
default. You must reconfigure the IP address and<br />
identity parameters if you use these settings.<br />
Off Off On Off Reserved. Do not use these combinations.<br />
Off Off On On<br />
Off On Off On<br />
Off On On Off<br />
Off On On On<br />
Off Off Off On Causes <strong>iSTAR</strong> <strong>Pro</strong> to reboot using the boot image instead of<br />
the main image.<br />
MAC Address<br />
When configuring an <strong>iSTAR</strong> Controller, it is necessary to supply the MAC address of<br />
the NIC card that is connected.<br />
The MAC address for the on-board 10BaseT NIC is displayed on a sticker just left of<br />
the Power LED.<br />
If a PCMCIA NIC card is used, the MAC address will be provided by the manufacturer.<br />
38
Change language