iSTAR Pro 4U Rack Mount Quick Start Installation Guide

More documents

Recommendations

Info

Cable Distances and Power Inputs Input Diagram Figure 22 shows the wiring diagram of an input connector FIGURE 22. Input Connector 32
Cable Distances and Power NO and NC Input Inputs The wiring of supervised inputs is shown in the next two figures. Note that the resistor network is different for NO and NC switches. Normally Open (NO) Wiring Normally Closed (NC) Wiring NOTE To comply with UL requirements, use shielded, minimum 22 AWG stranded, twisted pair cable for monitor points, DSMs, and REXs. Use Belden 9462 or equivalent. 33
Page 1 and 2: iSTAR Pro 4U Rack Mount Quick Start
Page 3 and 4: Features System Components The iSTA
Page 5 and 6: Features Mounting Instructions, 4 P
Page 7 and 8: Features Part Numbers TABLE 1. iSTA
Page 9 and 10: Specifications TABLE 5. Electrical
Page 11 and 12: COMPONENTS/ CONNECTIONS Front Panel
Page 13 and 14: Components/Connections Rear Connect
Page 15 and 16: Components/Connections Bottom Row R
Page 17 and 18: Components/Connections After wiring
Page 19 and 20: Components/Connections AC IN Indica
Page 21 and 22: Components/Connections APD8 Boards
Page 23 and 24: Components/Connections FIGURE 16. C
Page 25 and 26: Components/Connections Lock Power V
Page 27 and 28: Components/Connections Maglock RM R
Page 29 and 30: Components/Connections Fail Safe/Fa
Page 31: Cable Distances and Power Following
Page 35 and 36: GCM General Control Module GCM GENE
Page 37 and 38: GCM General Control Module GCM Diag
Page 39 and 40: GCM General Control Module GCM Batt
Page 41 and 42: ACM - Access Control Module(s) ACM
Page 43 and 44: ACM - Access Control Module(s) LEDs
Page 45 and 46: ACM - Access Control Module(s) 1 Wi
Page 47 and 48: ACM - Access Control Module(s) In t
Page 49: ACM - Access Control Module(s) C•

iSTAR Pro 4U Rack Mount Quick Start Installation Guide

Create successful ePaper yourself

Delete template?

Save as template?