Marin-5 Operator's Manual - CETAC Technologies
Marin-5 Operator's Manual - CETAC Technologies
Marin-5 Operator's Manual - CETAC Technologies
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
<strong>Marin</strong>-5 Operator’s <strong>Manual</strong><br />
Preparing for Installation<br />
Preparing for Installation<br />
This chapter discusses the requirements for choosing a location for the<br />
<strong>Marin</strong>-5 Enhanced Nebulizer System. It also describes how to unpack<br />
the <strong>Marin</strong>-5 before installation.<br />
__________________________________________________________________<br />
Unpacking the <strong>Marin</strong>-5<br />
Inspect external packaging upon receipt for signs of physical damage<br />
from rough handling or abuse during shipment. Inspect all items during<br />
unpacking and notify the carrier immediately of any visible or concealed<br />
damage.<br />
Remove packing checklist from the shipping container, and check off<br />
items against it. Leave accessories in the packing container until you<br />
are ready to install them on the <strong>Marin</strong>-5.<br />
__________________________________________________________________<br />
<strong>Marin</strong>-5 Packaging<br />
The shipping container unpacks in two layers from the top down:<br />
• Interface kit and completion kit<br />
• Small box with <strong>Marin</strong>-5 glassware (spray chamber/glassware and<br />
mounting stand)<br />
• <strong>Marin</strong>-5 Enhanced Nebulizer System<br />
NOTE:<br />
Do not throw away the factory packaging. Keep it for possible future use.<br />
This is one of the warranty conditions.<br />
CAUTION<br />
If water vapor condensation has formed on or inside the <strong>Marin</strong>-5, allow<br />
it to dry thoroughly before connecting it to an AC power source and<br />
operating it. Failure to do so may cause equipment damage.<br />
2-2