Marin-5 Operator's Manual - CETAC Technologies

More documents

Recommendations

Info

Marin-5 Operator’s Manual Maintaining the Marin-5 Figure 6-1. Interior View of the Marin-5 To rinse the Marin-5 glassware, perform the following steps: 1 Turn the AC power switch to off (0) and disconnect the AC power cord. If the power for the Marin-5 has been on, allow the unit to cool for 30 minutes. 6-6
Marin-5 Operator’s Manual Maintaining the Marin-5 2 Loosen the two rear thumbscrews and carefully slide the cover forward and past the cooling fan. 3 Open the front door, carefully place the nebulizer uptake line inside the Marin-5 and then completely remove the cover. 4 Carefully disconnect the nebulizer gas line from the concentric nebulizer and carefully remove the nebulizer. Then remove the nebulizer gas line from the Marin-5. 5 Carefully remove the nebulizer adapter fitting from the spray chamber. 6 Disconnect the multi-wire connector to the glassware. 7 Detach the metal clamp that secures the glassware to the condenser. 8 Disconnect the two liquid drain lines from the bottom of the glassware. 9 Loosen the black thumbscrew of the support holder and carefully remove the glassware. Carefully rinse the glassware with 20mL to 25mL portions of an appropriate solvent. For aqueous-based samples, 2% HNO3 is recommended. If deposits are observed on the inner walls of the glassware, the 2% HNO3 may be allowed to soak the glassware for an extended period of 1 hour or more. 10 See the note on page 6-5 for rinsing after the introduction of organic samples. 11 After cleaning with acid, rinse the glassware with deionized water. 12 Reverse steps 2 through 8 to reattach the glassware to the Marin-5. 6-7
Page 1 and 2:
Marin-5 Enhanced Nebulizer System O
Page 3 and 4:
Purchaser shall indemnify CETAC aga
Page 5 and 6:
FEDERAL COMMUNICATIONS COMMISSION (
Page 7 and 8:
Operator’s Manual Addendum Notice
Page 9 and 10:
Operator’s Manual Addendum Notice
Page 11 and 12: Table of Contents
Page 13 and 14: Marin-5 Operator’s Manual Content
Page 15: Marin-5 Operator’s Manual Content
Page 18 and 19: Marin-5 Operator’s Manual Preface
Page 24 and 25: Marin-5 Operator’s Manual Introdu
Page 26 and 27: Marin-5 Operator’s Manual Introdu
Page 28 and 29: Marin-5 Operator’s Manual Prepari
Page 30 and 31: Marin-5 Operator’s Manual Prepari
Page 32 and 33: Marin-5 Operator’s Manual Install
Page 44 and 45: Marin-5 Operator’s Manual Verifyi
Page 46 and 47: ICP-AES Optimization It is necessar
Page 48 and 49: 3 Adjust the Marin-5 heater tempera
Page 50 and 51: Oxygen addition may be needed to pr
Page 52 and 53: Marin-5 Operator’s Manual Using t
Page 58 and 59: Marin-5 Operator’s Manual Maintai
Page 68 and 69: Marin-5 Operator’s Manual Trouble
show all

Marin-5 Operator's Manual - CETAC Technologies

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?