Marin-5 Operator's Manual - CETAC Technologies
Marin-5 Operator's Manual - CETAC Technologies
Marin-5 Operator's Manual - CETAC Technologies
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
<strong>Marin</strong>-5 Operator’s <strong>Manual</strong><br />
Maintaining the <strong>Marin</strong>-5<br />
__________________________________________________________________<br />
Replacement of the Drain Pump Tubing<br />
The drain peristaltic pump tubing may need to be replaced due to wear<br />
or damage. If liquid is not being drained from the glassware, first adjust<br />
the tension on the peristaltic pump tubing. If any adjustment does not<br />
solve the drainage problem, then the tubing should be replaced.<br />
To replace the drain pump tubing, perform the following steps:<br />
1 Turn the AC power switch to off (0) and disconnect the AC<br />
power cord.<br />
2 Remove the 1/16 inch O.D. PFA Teflon® tubing (3 lines) from the<br />
top inlet side of the drain pump. Then remove the 3 longer lines<br />
of FEP-lined Tygon® tubing from the outlet side of the pump.<br />
3 Release the tension screws for all three channels of the drain<br />
pump.<br />
4 Carefully pull out the connector fittings from the drain pump<br />
tubing holder.<br />
5 Remove the tubing from the fittings and replace with new<br />
tubing.<br />
6 Reattach the drain tubing with the connector fittings to the<br />
drain pump tubing holder (inlet and outlet).<br />
7 Reconnect the 1/16 inch O.D. PFA Teflon® tubing (3 lines) to the<br />
top inlet side, and the longer tubing to the outlet side (3 lines) of<br />
the drain pump.<br />
8 Secure the tension screws for all three channels of the drain<br />
pump.<br />
9 Adjust the tension screws as needed for a steady flow of drain<br />
liquid.<br />
6-9