Stylistic 1200 Tech Reference Manual (PDF) - The Labs
Stylistic 1200 Tech Reference Manual (PDF) - The Labs
Stylistic 1200 Tech Reference Manual (PDF) - The Labs
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Peripheral Interface Specifications 5<br />
Specifications for peripheral interfaces on the <strong>Stylistic</strong> <strong>1200</strong> pen tablet are given in Table 5-5. For<br />
specifications on peripheral interfaces provided by the port replicator, see “Port Replicator Specifications”<br />
later in this chapter. Also note that peripheral interfaces for the <strong>Stylistic</strong> <strong>1200</strong> pen tablet are further<br />
described in Chapter 6 of this manual.<br />
Table 5-5 Peripheral Interface Specifications<br />
Feature Specification Comments<br />
PC Card Slots<br />
Two stacked PC Card slots<br />
Compliant with PC Card Standard Rev. 3.0<br />
Supports:<br />
CardBus<br />
Zoomed Video Port (slot 1 only)<br />
PCIC<br />
System accepts:<br />
Two Type I or Type II PC Cards, or<br />
one Type III PC Card<br />
IDE Interface Supports 1 IDE hard disk drive (2.5 in) IDE hard disk drive is preinstalled at factory.<br />
Keyboard Port 6-pin PS/2-style Supports Fujitsu 3.3-volt low-power<br />
keyboard and most PS/2-style keyboards.<br />
Parallel Port 25-pin D connector, female Operational modes: output only,<br />
bidirectional, ECP DMA channel 1, ECP<br />
DMA channel 3.<br />
Video Port Standard 15-pin video connector External monitor only or simultaneous with<br />
LCD.<br />
Serial Port A<br />
IrDA Port<br />
DC Power Input<br />
Audio Jacks<br />
DC Power Contacts<br />
System Interface<br />
Port<br />
RS-232C, female 9-pin D connector.<br />
NS 16C550 compatible, fully functional<br />
RS-232C serial port.<br />
Infrared LED built into pen tablet.<br />
Compliant with IrDA Standard Revision 1.1<br />
Supports: FIR (4 Mbps max),<br />
SIR (115 Kbps max)<br />
Range: approximately 1 M, 15 degrees from<br />
center<br />
16 VDC ±10%, 2.7 A<br />
Connector vendor: Hosiden<br />
(Hosiden part number HEC3900-01-010)<br />
This connector is a standard Japanese Type 5<br />
connector.<br />
Stereo microphone input mini jack<br />
Stereo headphone output mini jack<br />
2 surface contacts (+ and -) on lower edge of<br />
system (near system interface port<br />
connector).<br />
Input: 16 VDC ±10%, 2.7 A<br />
120-pin connector<br />
Connector Vendor: I-PEX Co. Ltd., (part<br />
number CT-30001-120T-IPEX - connector on<br />
pen tablet, CT-30002-120T-IPEX - connector<br />
on port replicator)<br />
Port replicator provides a second fully<br />
functional serial port (serial port B).<br />
Serial port B can be assigned to either the<br />
IrDA port on pen tablet or the 9-pin RS-232C<br />
serial port B connector on the port replicator.<br />
IrDA port is disabled when 9-pin connector is<br />
selected for the serial port B device.<br />
For use with FMWAC4A, FMWAC4B, and<br />
FMWAC4C AC adapters (AC adapter<br />
module CA01007-0520) or FMWCB2 auto<br />
adapter (CA01007-0360).<br />
External power can be connected to DC<br />
input connector on the pen tablet or the port<br />
replicator.<br />
See “Audio Jacks” in Chapter 6 of this<br />
manual for details on audio inputs and<br />
outputs.<br />
<strong>The</strong> DC power contacts and DC power input<br />
connectors on the pen tablet and port<br />
replicator are all diode “ORed” to the<br />
system’s 16 VDC input.<br />
For use with <strong>Stylistic</strong> <strong>1200</strong> port replicator.<br />
5-4 Specifications