Red Hat Enterprise Linux Installation Guide 5.2 - linux.meuhobby.com

More documents

Recommendations

Info

Chapter 17. Installing on IBM System z Systems boot. If you do not have DHCP client access or you are unsure what to provide here, please contact your network administrator. Note DHCP should not be chosen for qdio/qeth devices that are configured with OSA layer 3 support. Layer 3 does not provide MAC address or Address Resolution Protocol (ARP) abilities and so can not be used with network services that require them. Figure 17.15. Editing a Network Device Note Do not use the numbers as seen in this sample configuration. These values will not work for your own network configuration. If you are not sure what values to enter, contact your network administrator for assistance. 200
Time Zone Configuration If you have a hostname (fully qualified domain name) for the network device, you can choose to have DHCP (Dynamic Host Configuration Protocol) automatically detect it or you can manually enter the hostname in the field provided. Finally, if you entered the IP and Netmask information manually, you may also enter the Gateway address and the Primary and Secondary DNS addresses. 16. Time Zone Configuration Set your time zone by selecting the city closest to your <strong>com</strong>puter's physical location. Click on the map to zoom in to a particular geographical region of the world. From here there are two ways for you to select your time zone: • Using your mouse, click on the interactive map to select a specific city (represented by a yellow dot). A red X appears indicating your selection. • You can also scroll through the list at the bottom of the screen to select your time zone. Using your mouse, click on a location to highlight your selection. Figure 17.16. Configuring the Time Zone 201
Page 1 and 2:
Red Hat Enterprise Linux 5.2 Red Ha
Page 3 and 4:
Red Hat Enterprise Linux 5.2: Red H
Page 5 and 6:
Introduction ......................
Page 7 and 8:
4.3. Problems with the X Window Sys
Page 9 and 10:
Message ...........................
Page 11 and 12:
2. Upgrading Your System ..........
Page 13 and 14:
Introduction Welcome to the Red Hat
Page 15 and 16:
Document Conventions example: Go to
Page 17 and 18:
Where to Find Other Manuals If you
Page 19:
Part I. x86, AMD64, Intel® 64 and
Page 22 and 23:
Chapter 1. Itanium System Specific
Page 24 and 25:
Chapter 2. Steps to Get You Started
Page 26 and 27:
Page 28 and 29:
Page 31:
Chapter 3. System Specifications Li
Page 34 and 35:
Chapter 4. Installing on Intel® an
Page 36 and 37:
Page 38 and 39:
Page 40 and 41:
Page 42 and 43:
Page 44 and 45:
Page 46 and 47:
Page 48 and 49:
Page 50 and 51:
Page 52 and 53:
Page 54 and 55:
Page 56 and 57:
Page 58 and 59:
Page 60 and 61:
Page 62 and 63:
Page 64 and 65:
Page 66 and 67:
Page 68 and 69:
Page 70 and 71:
Page 72 and 73:
Page 74 and 75:
Page 76 and 77:
Page 78 and 79:
Page 80 and 81:
Page 82 and 83:
Page 84 and 85:
Page 87 and 88:
Chapter 5. Removing Red Hat Enterpr
Page 89 and 90:
Chapter 6. Troubleshooting Installa
Page 91 and 92:
Saving Traceback Messages Without a
Page 93 and 94:
Diskette Drive in run rc = self.tod
Page 95 and 96:
Problems with the X Window System (
Page 97 and 98:
Your Printer Does Not Work In /boot
Page 99 and 100:
Chapter 7. Driver Media for Intel a
Page 101:
Using a Driver Image During Install
Page 104 and 105:
Chapter 8. Additional Boot Options
Page 106 and 107:
Chapter 8. Additional Boot Options
Page 108 and 109:
Chapter 9. The GRUB Boot Loader cap
Page 110 and 111:
Chapter 9. The GRUB Boot Loader 4.
Page 112 and 113:
Chapter 9. The GRUB Boot Loader The
Page 114 and 115:
Chapter 9. The GRUB Boot Loader •
Page 116 and 117:
Chapter 9. The GRUB Boot Loader # s
Page 118 and 119:
Chapter 9. The GRUB Boot Loader For
Page 120 and 121:
102
Page 123 and 124:
Chapter 11. Steps to Get You Starte
Page 125 and 126:
Preparing for FTP and HTTP installa
Page 127 and 128:
Preparing for a Hard Drive Installa
Page 129 and 130:
Chapter 12. Installing on IBM Syste
Page 131 and 132:
A Note about Linux Virtual Consoles
Page 133 and 134:
The Text Mode Installation Program
Page 135 and 136:
Interface display a summary of avai
Page 137 and 138:
Installing via NFS 8. Performing a
Page 139 and 140:
Installing via HTTP Figure 12.7. FT
Page 141 and 142:
Welcome to Red Hat Enterprise Linux
Page 143 and 144:
Enter the Installation Number Figur
Page 145 and 146:
Disk Partitioning Setup Warning The
Page 147 and 148:
Create Default Layout Figure 12.14.
Page 149 and 150:
Partitioning Your System Tip [This
Page 151 and 152:
Disk Druid's Buttons to edit an exi
Page 153 and 154:
Recommended Partitioning Scheme •
Page 155 and 156:
Adding Partitions • Mount Point:
Page 157 and 158:
Network Configuration Figure 12.18.
Page 159 and 160:
Time Zone Configuration password to
Page 161 and 162:
Set Root Password Figure 12.21. Roo
Page 163 and 164:
Package Group Selection Note Users
Page 165 and 166:
Installing Packages To cancel this
Page 167 and 168: Chapter 13. Driver Media for IBM PO
Page 169 and 170: Chapter 14. Troubleshooting Install
Page 171 and 172: Trouble with Partition Tables This
Page 173 and 174: Unable to IPL from *NWSSTG 4. Probl
Page 175 and 176: Your Printer Does Not Work If you c
Page 177 and 178: Chapter 15. Additional Boot Options
Page 179 and 180: vnc this command allows you to inst
Page 181: Part III. IBM System z Architecture
Page 184 and 185: Chapter 16. Steps to Get You Starte
Page 196 and 197: Chapter 17. Installing on IBM Syste
Page 228 and 229: 210
Page 230 and 231: Chapter 19. Sample Parameter Files
Page 232 and 233: Chapter 19. Sample Parameter Files
Page 234 and 235: Chapter 20. Additional Boot Options
Page 240 and 241: Chapter 22. Additional Information
Page 265 and 266: Chapter 23. Upgrading Your Current
Page 267 and 268: Upgrading Your System Installing on
Page 269 and 270:
Chapter 24. Activate Your Subscript
Page 271 and 272:
Chapter 25. An Introduction to Disk
Page 273 and 274:
Partitions: Turning One Drive Into
Page 275 and 276:
Partitions within Partitions — An
Page 277 and 278:
of Extended Partitions Let us look
Page 279 and 280:
Making Room For Red Hat Enterprise
Page 281 and 282:
Partition Naming Scheme Figure 25.1
Page 283 and 284:
How Many Partitions 1.7. Disk Parti
Page 285:
Part V. Basic System Recovery When
Page 288 and 289:
Chapter 26. Basic System Recovery W
Page 290 and 291:
Chapter 26. Basic System Recovery I
Page 292 and 293:
274
Page 294 and 295:
Chapter 27. Rescue Mode on POWER Sy
Page 297 and 298:
Chapter 28. Kickstart Installations
Page 299 and 300:
Kickstart Options autopart (optiona
Page 301 and 302:
Kickstart Options Tip To look up us
Page 303 and 304:
Kickstart Options the proper device
Page 305 and 306:
Kickstart Options • cdrom — Ins
Page 307 and 308:
Kickstart Options The file /usr/sha
Page 309 and 310:
Kickstart Options networking (in ot
Page 311 and 312:
Kickstart Options For a detailed ex
Page 313 and 314:
Kickstart Options more information
Page 315 and 316:
Kickstart Options that may be used
Page 317 and 318:
Kickstart Options Allows the graphi
Page 319 and 320:
Package Selection raid swap raid /u
Page 321 and 322:
Example %pre #!/bin/sh hds="" mymed
Page 323 and 324:
Making the Kickstart File Available
Page 325 and 326:
Making the Installation Tree Availa
Page 327 and 328:
Starting a Kickstart Installation T
Page 329 and 330:
Starting a Kickstart Installation m
Page 331 and 332:
Starting a Kickstart Installation u
Page 333 and 334:
Chapter 29. Kickstart Configurator
Page 335 and 336:
Boot Loader Options Figure 29.2. In
Page 337 and 338:
Partition Information preserving th
Page 339 and 340:
Creating Partitions Figure 29.5. Cr
Page 341 and 342:
Network Configuration After creatin
Page 343 and 344:
Firewall Configuration Figure 29.9.
Page 345 and 346:
SELinux Configuration on port 1234
Page 347 and 348:
Package Selection After configuring
Page 349 and 350:
Pre-Installation Script Figure 29.1
Page 351 and 352:
Chroot Environment Figure 29.16. Po
Page 353 and 354:
Saving the File Figure 29.17. Previ
Page 355 and 356:
Chapter 30. Boot Process, Init, and
Page 357 and 358:
The Kernel following format — /bo
Page 359 and 360:
The /sbin/init Program K45named ->
Page 361 and 362:
Running Additional Programs at Boot
Page 363 and 364:
Shutting Down 4.2. Runlevel Utiliti
Page 365 and 366:
Chapter 31. PXE Network Installatio
Page 367 and 368:
Command Line Configuration The next
Page 369 and 370:
Performing the PXE Installation Aft
show all

Red Hat Enterprise Linux Installation Guide 5.2 - linux.meuhobby.com

Create successful ePaper yourself

Delete template?

Save as template?