Red Hat Enterprise Linux Installation Guide 5.2 - linux.meuhobby.com

Package Selection
After configuring the video card, click on the Monitor tab as shown in Figure 29.13, “X
Configuration - Monitor”.
Figure 29.13. X Configuration - Monitor
Probe for monitor is selected by default. Accept this default to have the installation program
probe for the monitor during installation. Probing works for most modern monitors. If this option
is selected and the installation program cannot successfully probe the monitor, the installation
program stops at the monitor configuration screen. To continue the installation process, select
your monitor from the list and click Next.
Alternatively, you can select your monitor from the list. You can also specify the horizontal and
vertical sync rates instead of selecting a specific monitor by checking the Specify hsync and
vsync instead of monitor option. This option is useful if the monitor for the system is not listed.
Notice that when this option is enabled, the monitor list is disabled.
9. Package Selection
329