Red Hat Enterprise Linux Installation Guide 5.2 - linux.meuhobby.com

Chapter 28. Kickstart Installations
since the installation program configures the network to find the kickstart file. For
example:
network --bootproto=dhcp --device=eth0
• --ip= — IP address for the machine to be installed.
• --gateway= — Default gateway as an IP address.
• --nameserver= — Primary nameserver, as an IP address.
• --nodns — Do not configure any DNS server.
• --netmask= — Netmask for the installed system.
• --hostname= — Hostname for the installed system.
• --ethtool= — Specifies additional low-level settings for the network device which will be
passed to the ethtool program.
• --essid= — The network ID for wireless networks.
• --wepkey= — The encryption key for wireless networks.
• --onboot= — Whether or not to enable the device at boot time.
• --class= — The DHCP class.
• --mtu= — The MTU of the device.
• --noipv4 — Disable IPv4 on this device.
• --noipv6 — Disable IPv6 on this device.
multipath (optional)
multipath --name= --device= --rule=
part or partition (required for installs, ignored for upgrades)
Creates a partition on the system.
If more than one Red Hat Enterprise Linux installation exists on the system on different
partitions, the installation program prompts the user and asks which installation to upgrade.
Warning
All partitions created are formatted as part of the installation process unless
--noformat and --onpart are used.
292