Red Hat Enterprise Linux Installation Guide 5.2 - linux.meuhobby.com

More documents

Recommendations

Info

Chapter 29. Kickstart Configurator Figure 29.8. Network Configuration If the system to be installed via kickstart does not have an Ethernet card, do not configure one on the Network Configuration page. Networking is only required if you choose a networking-based installation method (NFS, FTP, or HTTP). Networking can always be configured after installation with the Network Administration Tool (system-config-network). Refer to the Red Hat Enterprise Linux Deployment Guide for details. For each Ethernet card on the system, click Add Network Device and select the network device and network type for the device. Select eth0 to configure the first Ethernet card, eth1 for the second Ethernet card, and so on. 6. Authentication 324
Firewall Configuration Figure 29.9. Authentication In the Authentication section, select whether to use shadow passwords and MD5 encryption for user passwords. These options are highly recommended and chosen by default. The Authentication Configuration options allow you to configure the following methods of authentication: • NIS • LDAP • Kerberos 5 • Hesiod • SMB • Name Switch Cache These methods are not enabled by default. To enable one or more of these methods, click the appropriate tab, click the checkbox next to Enable, and enter the appropriate information for the authentication method. Refer to the Red Hat Enterprise Linux Deployment Guide for more information about the options. 325
Page 1 and 2:
Red Hat Enterprise Linux 5.2 Red Ha
Page 3 and 4:
Red Hat Enterprise Linux 5.2: Red H
Page 5 and 6:
Introduction ......................
Page 7 and 8:
4.3. Problems with the X Window Sys
Page 9 and 10:
Message ...........................
Page 11 and 12:
2. Upgrading Your System ..........
Page 13 and 14:
Introduction Welcome to the Red Hat
Page 15 and 16:
Document Conventions example: Go to
Page 17 and 18:
Where to Find Other Manuals If you
Page 19:
Part I. x86, AMD64, Intel® 64 and
Page 22 and 23:
Chapter 1. Itanium System Specific
Page 24 and 25:
Chapter 2. Steps to Get You Started
Page 26 and 27:
Page 28 and 29:
Page 31:
Chapter 3. System Specifications Li
Page 34 and 35:
Chapter 4. Installing on Intel® an
Page 36 and 37:
Page 38 and 39:
Page 40 and 41:
Page 42 and 43:
Page 44 and 45:
Page 46 and 47:
Page 48 and 49:
Page 50 and 51:
Page 52 and 53:
Page 54 and 55:
Page 56 and 57:
Page 58 and 59:
Page 60 and 61:
Page 62 and 63:
Page 64 and 65:
Page 66 and 67:
Page 68 and 69:
Page 70 and 71:
Page 72 and 73:
Page 74 and 75:
Page 76 and 77:
Page 78 and 79:
Page 80 and 81:
Page 82 and 83:
Page 84 and 85:
Page 87 and 88:
Chapter 5. Removing Red Hat Enterpr
Page 89 and 90:
Chapter 6. Troubleshooting Installa
Page 91 and 92:
Saving Traceback Messages Without a
Page 93 and 94:
Diskette Drive in run rc = self.tod
Page 95 and 96:
Problems with the X Window System (
Page 97 and 98:
Your Printer Does Not Work In /boot
Page 99 and 100:
Chapter 7. Driver Media for Intel a
Page 101:
Using a Driver Image During Install
Page 104 and 105:
Chapter 8. Additional Boot Options
Page 106 and 107:
Page 108 and 109:
Chapter 9. The GRUB Boot Loader cap
Page 110 and 111:
Chapter 9. The GRUB Boot Loader 4.
Page 112 and 113:
Chapter 9. The GRUB Boot Loader The
Page 114 and 115:
Chapter 9. The GRUB Boot Loader •
Page 116 and 117:
Chapter 9. The GRUB Boot Loader # s
Page 118 and 119:
Chapter 9. The GRUB Boot Loader For
Page 120 and 121:
102
Page 123 and 124:
Chapter 11. Steps to Get You Starte
Page 125 and 126:
Preparing for FTP and HTTP installa
Page 127 and 128:
Preparing for a Hard Drive Installa
Page 129 and 130:
Chapter 12. Installing on IBM Syste
Page 131 and 132:
A Note about Linux Virtual Consoles
Page 133 and 134:
The Text Mode Installation Program
Page 135 and 136:
Interface display a summary of avai
Page 137 and 138:
Installing via NFS 8. Performing a
Page 139 and 140:
Installing via HTTP Figure 12.7. FT
Page 141 and 142:
Welcome to Red Hat Enterprise Linux
Page 143 and 144:
Enter the Installation Number Figur
Page 145 and 146:
Disk Partitioning Setup Warning The
Page 147 and 148:
Create Default Layout Figure 12.14.
Page 149 and 150:
Partitioning Your System Tip [This
Page 151 and 152:
Disk Druid's Buttons to edit an exi
Page 153 and 154:
Recommended Partitioning Scheme •
Page 155 and 156:
Adding Partitions • Mount Point:
Page 157 and 158:
Network Configuration Figure 12.18.
Page 159 and 160:
Time Zone Configuration password to
Page 161 and 162:
Set Root Password Figure 12.21. Roo
Page 163 and 164:
Package Group Selection Note Users
Page 165 and 166:
Installing Packages To cancel this
Page 167 and 168:
Chapter 13. Driver Media for IBM PO
Page 169 and 170:
Chapter 14. Troubleshooting Install
Page 171 and 172:
Trouble with Partition Tables This
Page 173 and 174:
Unable to IPL from *NWSSTG 4. Probl
Page 175 and 176:
Your Printer Does Not Work If you c
Page 177 and 178:
Page 179 and 180:
vnc this command allows you to inst
Page 181:
Part III. IBM System z Architecture
Page 184 and 185:
Page 186 and 187:
Page 188 and 189:
Page 190 and 191:
Page 192 and 193:
Page 194 and 195:
Page 196 and 197:
Page 198 and 199:
Page 200 and 201:
Page 202 and 203:
Page 204 and 205:
Page 206 and 207:
Page 208 and 209:
Page 210 and 211:
Page 212 and 213:
Page 214 and 215:
Page 216 and 217:
Page 218 and 219:
Page 220 and 221:
Page 222 and 223:
Page 224 and 225:
Page 226 and 227:
Page 228 and 229:
210
Page 230 and 231:
Chapter 19. Sample Parameter Files
Page 232 and 233:
Chapter 19. Sample Parameter Files
Page 234 and 235:
Page 236 and 237:
Page 238 and 239:
Page 240 and 241:
Chapter 22. Additional Information
Page 242 and 243:
Page 244 and 245:
Page 246 and 247:
Page 248 and 249:
Page 250 and 251:
Page 252 and 253:
Page 254 and 255:
Page 256 and 257:
Page 258 and 259:
Page 260 and 261:
Page 262 and 263:
Page 265 and 266:
Chapter 23. Upgrading Your Current
Page 267 and 268:
Upgrading Your System Installing on
Page 269 and 270:
Chapter 24. Activate Your Subscript
Page 271 and 272:
Chapter 25. An Introduction to Disk
Page 273 and 274:
Partitions: Turning One Drive Into
Page 275 and 276:
Partitions within Partitions — An
Page 277 and 278:
of Extended Partitions Let us look
Page 279 and 280:
Making Room For Red Hat Enterprise
Page 281 and 282:
Partition Naming Scheme Figure 25.1
Page 283 and 284:
How Many Partitions 1.7. Disk Parti
Page 285:
Part V. Basic System Recovery When
Page 288 and 289:
Chapter 26. Basic System Recovery W
Page 290 and 291:
Chapter 26. Basic System Recovery I
Page 292 and 293: 274
Page 294 and 295: Chapter 27. Rescue Mode on POWER Sy
Page 297 and 298: Chapter 28. Kickstart Installations
Page 299 and 300: Kickstart Options autopart (optiona
Page 301 and 302: Kickstart Options Tip To look up us
Page 303 and 304: Kickstart Options the proper device
Page 305 and 306: Kickstart Options • cdrom — Ins
Page 307 and 308: Kickstart Options The file /usr/sha
Page 309 and 310: Kickstart Options networking (in ot
Page 311 and 312: Kickstart Options For a detailed ex
Page 313 and 314: Kickstart Options more information
Page 315 and 316: Kickstart Options that may be used
Page 317 and 318: Kickstart Options Allows the graphi
Page 319 and 320: Package Selection raid swap raid /u
Page 321 and 322: Example %pre #!/bin/sh hds="" mymed
Page 323 and 324: Making the Kickstart File Available
Page 325 and 326: Making the Installation Tree Availa
Page 327 and 328: Starting a Kickstart Installation T
Page 329 and 330: Starting a Kickstart Installation m
Page 331 and 332: Starting a Kickstart Installation u
Page 333 and 334: Chapter 29. Kickstart Configurator
Page 335 and 336: Boot Loader Options Figure 29.2. In
Page 337 and 338: Partition Information preserving th
Page 339 and 340: Creating Partitions Figure 29.5. Cr
Page 341: Network Configuration After creatin
Page 345 and 346: SELinux Configuration on port 1234
Page 347 and 348: Package Selection After configuring
Page 349 and 350: Pre-Installation Script Figure 29.1
Page 351 and 352: Chroot Environment Figure 29.16. Po
Page 353 and 354: Saving the File Figure 29.17. Previ
Page 355 and 356: Chapter 30. Boot Process, Init, and
Page 357 and 358: The Kernel following format — /bo
Page 359 and 360: The /sbin/init Program K45named ->
Page 361 and 362: Running Additional Programs at Boot
Page 363 and 364: Shutting Down 4.2. Runlevel Utiliti
Page 365 and 366: Chapter 31. PXE Network Installatio
Page 367 and 368: Command Line Configuration The next
Page 369 and 370: Performing the PXE Installation Aft
show all

Red Hat Enterprise Linux Installation Guide 5.2 - linux.meuhobby.com

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?