Red Hat Enterprise Linux Installation Guide 5.2 - linux.meuhobby.com

Kickstart Options
that may be used in yum repo config files are not supported here. You may use one of
either this option or --baseurl, not both.
rootpw (required)
Sets the system's root password to the argument.
rootpw [--iscrypted]
• --iscrypted — If this is present, the password argument is assumed to already be
encrypted.
selinux (optional)
Sets the state of SELinux on the installed system. SELinux defaults to enforcing in
anaconda.
selinux [--disabled|--enforcing|--permissive]
• --enforcing — Enables SELinux with the default targeted policy being enforced.
Note
If the selinux option is not present in the kickstart file, SELinux is enabled and
set to --enforcing by default.
• --permissive — Outputs warnings based on the SELinux policy, but does not actually
enforce the policy.
• --disabled — Disables SELinux completely on the system.
For complete information regarding SELinux for Red Hat Enterprise Linux, refer to the Red
Hat Enterprise Linux Deployment Guide.
services (optional)
Modifies the default set of services that will run under the default runlevel. The services
listed in the disabled list will be disabled before the services listed in the enabled list are
enabled.
• --disabled — Disable the services given in the comma separated list.
• --enabled — Enable the services given in the comma separated list.
shutdown (optional)
Shut down the system after the installation has successfully completed. During a kickstart
installation, if no completion method is specified, the reboot option is used as default.
The shutdown option is roughly equivalent to the shutdown command.
297