Red Hat Enterprise Linux Installation Guide 5.2 - linux.meuhobby.com

Chapter 29. Kickstart Configurator
insmod, install, ip, ipaddr, ipcalc, ipcrm, ipcs, iplink, iproute, iptunnel, kill,
killall, lash, last, length, less, linux32, linux64, ln, load_policy, loadfont,
loadkmap, login, logname, losetup, ls, lsattr, lsmod, lzmacat, makedevs, md5sum, mdev,
mesg, mkdir, mke2fs, mkfifo, mkfs.ext2, mkfs.ext3, mkfs.minix, mknod, mkswap, mktemp,
modprobe, more, mount, mountpoint, msh, mt, mv, nameif, nc, netstat, nice, nohup,
nslookup, od, openvt, passwd, patch, pidof, ping, ping6, pipe_progress, pivot_root,
printenv, printf, ps, pwd, rdate, readlink, readprofile, realpath, renice, reset, rm,
rmdir, rmmod, route, rpm, rpm2cpio, run-parts, runlevel, rx, sed, seq, setarch,
setconsole, setkeycodes, setlogcons, setsid, sh, sha1sum, sleep, sort,
start-stop-daemon, stat, strings, stty, su, sulogin, sum, swapoff, swapon, switch_root,
sync, sysctl, tail, tar, tee, telnet, telnetd, test, tftp, time, top, touch, tr,
traceroute, true, tty, tune2fs, udhcpc, udhcpd, umount, uname, uncompress, uniq,
unix2dos, unlzma, unzip, uptime, usleep, uudecode, uuencode, vconfig, vi, vlock, watch,
watchdog, wc, wget, which, who, whoami, xargs, yes, zcat, zcip
For a description of any of these commands, run:
busybox command --help
In addition to the aforementioned commands, the following commands are provided in their full
featured versions:
anaconda, bash, bzip2, jmacs, ftp, head, joe, kudzu-probe, list-harddrives, loadkeys,
mtools, mbchk, mtools, mini-wm, mtools, jpico, pump, python, python2.4, raidstart,
raidstop, rcp, rlogin, rsync, setxkbmap, sftp, shred, ssh, syslinux, syslogd, tac,
termidx, vncconfig, vncpasswd, xkbcomp, Xorg, Xvnc, zcat
Caution
Do not include the %pre command. It is added for you.
Note
The pre-installation script is run after the source media is mounted and stage 2 of
the bootloader has been loaded. For this reason it is not possible to change the
source media in the pre-installation script.
11. Post-Installation Script
332