Seko Twindose 35 Series Inst.. - UK

TWINDOSE 35 – System for dishwashers
5.1.3 Dosing the detergent in timer mode
To select the timer mode for the detergent pump, DIP-switch 2 must be switched to the OFF (PROBELESS)
position. The pump will run at top speed for the time set using potentiometer POT3.
CAL. OFF
CAL. ON
In this configuration, POT4 regulates the detergent dosing time during the rinsing phase, while detergent dosing
during the 1 st charging phase is controlled by potentiometer POT5 that sets the dosing time when a signal is
received on the CHARGE SIGNAL terminal.
5.2 RINSE AID DOSING
When the TWINDOSE 35 unit receives a signal on the RINSE SIGNAL terminal, the rinse aid pump doses in terms
of a volumetric (speed) setting or timer setting, depending on the selection made using DIP-switch 4 (RINSE
SPEED / RINSE TIME).
5.2.1 Dosing the rinse aid in by setting the volume (RINSE SPEED)
CAL. OFF
CAL. ON
If the volumetric (RINSE SPEED) dosing mode is selected:
• Set DIP-switch 4 (RINSE SPEED / RINSE TIME) to RINSE SPEED (OFF position).
• Set the rinse aid pump flow rate to between 0% and 100% of the top speed (using potentiometer POT1).
To change the pump speed, simply turn potentiometer POT1 clockwise to increase speed and anticlockwise to
reduce speed.
5.2.2 Dosing rinse aid by setting the timer (RINSE TIME)
CAL. OFF
CAL. ON
If the timer dosing mode is selected:
• Set DIP-switch 4 (RINSE SPEED / RINSE TIME) to RINSE TIME (ON position).
• Set the dosing time for the rinse aid pump to between 1 and 255 seconds (using potentiometer POT1).
To change the pump dosing time, simply turn potentiometer POT1 clockwise to increase and anticlockwise to
reduce.
TWINDOSE 35 code 0000136655 rev. 1.0 22