Seko Twindose 35 Series Inst.. - UK

TWINDOSE 35 – System for dishwashers
2 INSTALLATION
Attach the equipment to a wall near the dishwashing machine, using the wall anchors supplied in the pack. It is
best to keep the equipment at a height that is within 1,5 m of the level of the liquid to be sucked up.
Before proceeding with installation, observe all applicable legal prescriptions related to electrical and plumbing
connections to make sure that the system is installed safety and correctly. Refer to the wiring diagram for the
dishwashing machine when forming electrical connections.
WARNING: Do not fit the equipment in the way of steam outlets as this could cause a short circuit,
resulting in permanent damage to the equipment.
Installing the TWINDOSE 35 near the steam vents from the dishwasher may cause the TWINDOSE 35
circuit to overheat, which could cause damage or result in difficulty with the way the equipment operates.
2.1 INSTALLING THE SYSTEM
• Find a suitable position for installing the TWINDOSE 35.
• Use the brackets and fixings supplied for installation.
• Using the bracket as a drilling template, mark out the position of the holes.
• Use a drill to make the holes in the wall.
• Put the wall plugs in the holes.
• Fix the brackets in position (flat side against the wall with the holes at the bottom), using the screws provided.
• Insert the bracket you have just fixed to the wall into its seating in the back of the TWINDOSE 35 (Fig. 1).
• To open the TWINDOSE 35, unscrew the upper screws on the front cover by ¼ turn, and hold the cover until it
is fully open.
Fig. 1
TWINDOSE 35 code 0000136655 rev. 1.0 6