Seko Twindose 35 Series Inst.. - UK

More documents

Recommendations

Info

TWINDOSE 35 – System for dishwashers TWINDOSE 35 code 0000136655 rev. 1.0 32
TWINDOSE 35 – System for dishwashers WASH SIGNAL DETERGENT PUMP When this signal is activated, the detergent pump is activated only if the conductometric sensor detects a concentration of detergent in the tank, below the set point. When the concentration value detected in the tank falls below the set point, the control circuit automatically activates the detergent pump and stops when the concentration in the tank rises more than 10% above the set value. If TWINDOSE 35 does not receive any signal from the WASH SIGNAL terminal, the control circuit does not activate dosage of the detergent, even if the conductometric sensor detects that the detergent concentration is below the set point. If the required concentration of detergent (set point) is not reached within the time set by the OFA using POT4 (OFA TIME): • The buzzer alarm sounds intermittently. • The alarm LED flashes OFA 1 ALARM • The relay output is activated • The pumps continue dosing. If the correct concentration of detergent is not reached within two OFA time intervals • The buzzer alarm sounds continuously. • The LED alarm stays on OFA 2 ALARM • The relay output is activated • The pumps stop dosing. To reset the alarm status, eliminate the cause and restart the system. TWINDOSE 35 code 0000136655 rev. 1.0 33
Page 1 and 2: TWINDOSE 35 - System for dishwasher
Page 31: TWINDOSE 35 - System for dishwasher

Seko Twindose 35 Series Inst.. - UK

Create successful ePaper yourself

Delete template?

Save as template?