Manual (PDF) - Rose Electronics

commands to instruct the KVM Switch module to exercise an option must be configured to
either the “Command, Keyboard Control” tab or the Hosts tab.
The easiest way to switch to a CPU port is invoke the Computer select window. To do this
connect using the VNC viewer, press and release the Ctrl key, then within 2 seconds, press the
Esc key. The computer select window will display as shown below, listing the computers
connected to the Vista Remote 2.
Using the up or down arrow keys, select the computer port to switch to and press enter. You
will be immediately switched to that CPU port and the connected computer’s video will display.
You will have complete control (if your security profile permits it) of that computer. All functions
can be performed as if you were directly connected to that computer. Files can be opened,
edited, and saved, and applications installed on that computer can be executed.
38 Vista Remote 2 Installation and Operations Manual