Manual (PDF) - Rose Electronics

Access
Use the arrow buttons to select either ‘Allow’ or ‘Deny’ as appropriate.
1 Enter the base network address, the mask and select the appropriate access setting.
2 Click the OK button.
To reorder access control entries
IMPORTANT: When reordering, ensure that any specific allowed addresses are listed higher in
the list than any denied addresses. Take care not to invoke any deny access settings that
would exclude valid users.
1 In the access control list, click on the entry to be moved.
2 Click the Up or Down buttons as appropriate.
To edit/remove access control entries
1 In the access control list, click on the appropriate entry.
2 Click either the Edit or Remove button as appropriate.
Appendix E – VNC Viewer connection options
When you are connecting to the Vista Remote 2 unit using the VNC
viewer, a number of options are available.
Click the Options… button
There are six tabbed pages of options:
52 Vista Remote 2 Installation and Operations Manual