condair FF2

19
4.2 Accessories and options
Accessories
Accessory
High-pressure hose for
high-pressure piping
Anti-chafe spiral hose
RJ45 bus cable
Description
High-pressure hoses for establishing the high-pressure
piping between the high-pressure connectors of the
pump.
Hoses of 2 m, 5 m or 10 m length available (from stock)
The anti-chafe spiral hose protects the high-pressure
hoses in locations where they are subject to get in touch
with each other or with other system components.
Length: 3 m
The bus cable connects the control units of a masterslave
configuration.
Length: 10 m or 20 m
Options
Option
Floor stand for pump station
Droplet separator
Remote operating and fault
indication
Conductivity monitoring
Flushing valve Y6
e-LINKS FF2
Floor stand for pump station
Floor stand made of corrosion resistant steel, for mounting
the pump station at a convenient height for easy operation.
Droplet separator in frame construction made of corrosion
resistant steel equipped with collector meshes with
a special biocide coating.
With unfavourable flow conditions and/or high air speed
in the duct additionally a deflection sheet is provided for
the optimization of the incident air flow of the first droplet
separator.
Print with relay contacts for the remote indication of the
following operating conditions: Unit on, Humidification,
Error and Maintenance.
The conductivity monitoring, consisting of the conductivity
sensor and the conductivity print, monitors the
electrical conductivity of the water and outputs an error
message if the lower limit value is exceeded.
Flushing valve for the automatic flushing of the high
pressure piping during operation. The flushing valve is
installed directly to the step valve block.
Gateway to connect the Condair FF2 to a building management
system. Two versions are available:
BACnet/IP or LonWorks