condair FF2
condair FF2
condair FF2
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
45<br />
8.6 Changing the oil of the piston pump<br />
WARNING!<br />
Strictly follow all local regulations on environmental protection when changing the oil. Bring the old<br />
oil to waste oil collecting point. In no case dispose of oil into the environment!<br />
1. Put the system out of service according to chapter 7.4 and secure it to prevent inadvertent<br />
start-up.<br />
2. Open the waste oil screw (depending on the model the screw is on the bottom or on the side of<br />
the pump) using a open-end wrench and let the oil drain into the existing oil tub.<br />
Note: If the oil is milky white (oil contains water) the piston packings must be replaced (see<br />
chapter 7.5.2).<br />
3. Install the waste oil screw and fasten it with the open-end wrench.<br />
4. Carefully remove the oil tub, then empty the tub into a lockable waste oil container. Correctly<br />
dispose of the waste oil according the applicable local regulation.<br />
5. Clean oil tub and relocate it under the pump again.<br />
6. Remove the yellow-black oil filler cap and top up HD-SAE 30 motor oil or 15 W40 multigrade oil<br />
(approx. 0.4 l...1.0l depending on the model) until the level is just in the middle of the inspection<br />
glass (located above the waste oil screw).<br />
7. Relocate the oil filler cap.