condair FF2

More documents

Recommendations

Info

28 5.3.3 Mounting the pump station Mount the pump station at the desired location in accordance with the following figure directly to the floor (left figure) or mount the unit on the optional floor stand (right figure). 855 347,5 120 327.5 347,5 327.5 120 120 327.5 347,5 327.5 120
29 5.3.4 Water installation Master Slave 1...3 Y6 ** Y3 Y4 Y5 Y3 Y4 Y5 M20x1.5 ø19 mm hose connector or G 1/2" inside thread Notes on water installation – Use hoses to connect the supply flushing line and the tub drain to an open drain funnel (make sure to install the hoses correctly). – The working pressure flushing valve Y6 (**) is mounted directly to the step valve block of the Master unit (stand-alone system) or the last Slave unit (Compound systems). The drain hose of the flushing valve is to be connected to an open drain funnel (make sure to install the hose correctly). – Use only the optional high-pressure hoses to establish the high-pressure piping between the high-pressure connection of the pump station and the step valve block (or between step valve blocks of the Slave units, respectively). Other hoses may get damaged in operation and cause system breakdown.
Page 1: Condair FF2 Adiabatic High-Pressure
Page 4 and 5: 1 Introduction 1.1 To the very begi
Page 6 and 7: 2 For your safety General Every per
Page 8 and 9: 3 Overview of Condair FF2 3.1 Conda
Page 10 and 11: 10 3.2 Pump station Overview 15 14
Page 12 and 13: 12 3.3 Humidifier unit 1 2 3 4 5 6
Page 14 and 15: 14 3.4 Functional description 5 380
Page 16 and 17: 16 General Via the stop valve (8) t
Page 18 and 19: 18 4 Notes on planning Prior to des
Page 20 and 21: 20 5 Installation works 5.1 Importa
Page 22 and 23: 22 2. Mounting the pipe supports: F
Page 24 and 25: 24 6. Mounting the step valve block
Page 26 and 27: 26 5.3 Mounting the pump station 5.
Page 30 and 31: 30 - Important! Before connecting,
Page 32 and 33: 32 5.5 Electrical installation 5.5.
Page 34 and 35: 34 5.5.3 Notes on electric installa
Page 36 and 37: 36 6 Initial commissioning It is ma
Page 38 and 39: 38 7 Operation 7.1 Display and oper
Page 40 and 41: 40 7.3 Inspections during operation
Page 42 and 43: 42 8.2 Maintenance intervals To ens
Page 44 and 45: 44 8.5 Removal of components 8.5.1
Page 46 and 47: 46 9 Troubleshooting 9.1 Important
Page 48 and 49: 48 Error Cause Remedy Excessive flu
Page 50 and 51: 50 10 Product data 10.1 Technical s
Page 52 and 53: 52 10 Appendix 10.1 Diagram h,x
Page 54 and 55: Notes
Page 56: Consulting, Sales and Service: Solu

condair FF2

Create successful ePaper yourself

Delete template?

Save as template?