Tutorial.pdf

Changing the values of sweep iterations.
In the Parameter Sweeps tab you can enter the values directly in the table, or you can set the
fist and the last value and use the Sweep iteration spread tool:
• In the Parameter Sweeps tab, enter the value for the Power in the first cell, -50 dBm,
• Enter the value for the Power in the last cell, 0 dBm,
• Select the entire table column,
• In the Tools menu, select “Sweep Iterations Spread->Linear”
These steps are described in Figure 65:
Figure 65 -Entering values for all iterations
47