USER'S MANUAL Ladder Editor 32 version 1.2 - Motoman

MOTOMAN ROBOTICS EUROPE
User’s manual Ladder Editor 32
Setting relay no., register no. and
Created: 96-01-31 Revised: 01-04-05 Doc. name: Mrs55130-ch10.fm
Page: 37
10.6 Setting relay no., register no. and constants
Relay No., register No. and constants can be set for each ladder parts. Set these
values in the following manner.
How to operate
1) Enter the set value input mode.
Select [Tool] – [Mode] – [Input No.], or select from the parts control tool
bar (refer to paragraph "Parts control tool bar").
2) Select the ladder parts to which the set values are input in the "ladder editing"
display.
Left-click the mouse on the ladder parts in the "ladder editing" display, and
the "set value input" dialog box appears.
Note!
The number of setting items in the [Input Value] dialog box differs
depending on the ladder parts.
3) Input the set values.
Select the type of the set value in the combo box of the [Input Value] dialog
box, and then input a value suitable for the type of the set value.
Click the [OK] button to set the values.
■ Setting Values Using a Pop-up Menu
Set values can also be set in the following manner using a pop-up menu. The
pop-up menu appears by right-clicking the mouse.
How to operate
Fig.29 [Input Value] Dialog Box
1) Right-click the mouse on the ladder parts to which the set values are input,
and select the pop-up menu.
Right-click the mouse on the ladder parts to which the set values are input in
the "ladder editing" display, and the pop-up menu appears. Select the [Input
No.], and the [Input Value] dialog box appears.
2) Input the set values.
Input the set values in the [Input Value] dialog box.