Electronic Relays, Relay, HMI, Control, PLCs ... - Moeller Electric Parts

http://catalog.moeller.net Moeller HPL0211-2007/2008
Technical Data
Switched-mode power supply units
4/155
SN3-050-BU8 SN3-100-BV8 SN3-200-BV8 SN3-050-EU8 SN3-100-EU8 SN3-200-EU8
Input circuit
Rated input voltage V 110…240 AC 110…240 AC 110…240 AC 110…240 AC
Switch position 110 V – 110-120 AC 110-120 AC – – –
Switch position 230 V – 220-240 AC 220-240 AC – – –
Input voltage range V 85…264 AC – – 85…264 AC 85…264 AC 85…264 AC
Input voltage range V 100…350 DC – – 100…350 DC 100…350 DC 100…350 DC
Switch position 110 V AC V – 85-132 AC 85-132 AC – – –
Switch position 230 V AC V – 184-264 AC 184-264 AC – – –
Switch position 230 V DC V – 220-350 DC 220-350 DC – – –
Supply frequency
Rated value Hz 50/60 50/60 50/60 50/60 50/60 50/60
Range Hz 47…63 47…63 47…63 47…63 47…63 47…63
Current consumption
At 110 … 240 V AC A Approx.
2.2…1.2
Switch position 110 V AC A Approx. – Approx.
4.2…4.0
Switch position 230 V AC A Approx. – Approx.
2.4…2.2
Approx. – Approx. – Approx.
2.2…1.2
Approx.
9.0…8.0
Approx.
4.4…4.0
Approx.
3.5…1.6
Approx.
5.5…2.5
Approx. – Approx. – Approx. –
Approx. – Approx. – Approx. –
Power consumption W Normally 135 Normally 269 Normally 538 Normally 135 Normally 269 Normally 538
Inrush current limiter/i 2t (cold start) F 23 A /
approx. 0.9 A 2s
F 40 A /
approx. 1.8 A 2s
F 70 A /
approx. 8 A 2s
F 23 A /
approx. 0.9 A 2s
F 33 A /
approx. 0.2 A 2s
F 40 A /
approx. 1.9 A 2s
Mains failure bridging ms typically f 100 typically f 50 typically f 50 typically f 100 typically f 40 typically f 40
Run-up time after mains voltage applied ms Normally f
100
Normally f 10 Normally f 20 Normally f
100
Normally f 5 Normally f
370
Transient overvoltage protection Varistors Varistors Varistors Varistors Varistors Varistors
Internal input fuse (device protection, not
accessible)
4 AT 6.3 AT 12 AF 4 AT 6.3 AT 12 AF
Discharge current to PE mA < 3.5 mA < 3.5 mA < 3.5 mA < 3.5 mA < 3.5 mA < 3.5 mA
Output circuit
L+, L+, L-, L- Proof against short-circuit, no-load and overload
Rated output voltage V 24 DC 24 DC 24 DC 24 DC 24 DC 24 DC
Tolerance -1…+5 % -1…+5 % -1…+5 % -1…+5 % -1…+5 % -1…+5 %
Setting range for the output voltage fixed 24 V DC fixed 24 V DC fixed 24 V DC 22…28 V DC; ex-works set to 24 V g0.5%
Rated output power W 120 240 480 120 240 480
Rated output current Tu F 60 °C A 5 10 20 5 10 20
Peak output current (power reserves) Tu F 40 °C A Normally F
7.25
Normally F
12.25
Normally F
22.5
Normally F
7.25
Normally F
12.25
Normally F
22.5
Derating 60 °C F Tu F 70 °C
Control deviation at
2.5 % per Kelvin temperature increase
Load change 10…90 %, static Normally
g0.1 % g0.1 % g0.1 % g0.05 % g0.05 % g0.05 %
Load change 10…90 %, dynamic Normally
g3 % g3 % g3 % g3 % g3 % g3 %
Controller acting time ms Normally 1 Normally 1 Normally 1 Normally 1 Normally 1 Normally 1
Input voltage deviation g10 % Normally g0.05 % Normally g0.05 % Normally g0.05 % Normally g0.05 % Normally g0.05 % Normally g0.05 %
Rise time 10…90 % ms Normally F 30 Normally F 5 Normally F 15 Normally F 30 Normally F 4 Normally F 12
Residual ripple and switching peaks 20 MHz typically < 50 mVss
Can be switched in parallel yes, up to 5 devices for redundancy and for power increase, non symetrical current
Series connection capability yes, for voltage increase
Resistance to reverse feed yes, limited to approx. 35 V AC
Power factor correction (PFC) No Yes
Status indication OUTPUT OK: LED green
Overload characteristics a AWA2727-2317 (www.moeller.net/support) a AWA2727-2318 (www.moeller.net/support)
Behaviour on short-circuit continuously with current limitation
Current limitation at short-circuit A Approx. 11 Approx. 19 Approx. 25 Approx. 11 Approx. 19 Approx. 25
Short-circuit protection Proof against sustained short circuit
Overload protection thermal protection
Capacitive load starting Not restricted
Notes
1) At U f 264 V DC additionally suitable, use external fuse.
For Moeller Electric Sales and Support call KMparts.com (866) 595-9616
SN3
Switched-mode power supply units,
power supply units