FS1575_2575_5075 Installation Manual E1 6-15-2012 - Furuno USA
FS1575_2575_5075 Installation Manual E1 6-15-2012 - Furuno USA
FS1575_2575_5075 Installation Manual E1 6-15-2012 - Furuno USA
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
2. WIRING<br />
2.3 Control Unit<br />
Connect the Transceiver Unit to the Control Unit with the cable with the D-sub <strong>15</strong>-pin connector<br />
at both ends. Connect a single Control Unit to the CONTROLLER 1 port. (This port has priority<br />
when two Control Units are connected.) Connect a No.2 Control Unit to the CONTROLLER 2 port.<br />
Connect the handset HS-2003 to the HANDSET port at the rear of the Control Unit. For other<br />
handset or microphone, connect to the HANDSET REAR port.<br />
2.4 External Equipment<br />
Connect cables for external equipment to the T-IF Board in the Transceiver Unit.<br />
GNSS<br />
This radiotelephone can receive the following sentences in IEC 61162-1 (ed.2nd) format. Use the<br />
cable TTYCS-1/TTYCSLA-1 (or the equivalent) to connect the equipment to IEC 61162-1 of TB6<br />
in the Transceiver Unit.<br />
Data<br />
Position info, Position fix<br />
Time info<br />
Alarm Unit IC-350<br />
Sentence, priority order<br />
GNS>GGA>RMC>GLL<br />
ZDA>RMC<br />
Connect the Alarm Unit IC-350 to TB7 in the Transceiver Unit with the cable TTYCS-4/TTYCSLA-<br />
4 (or the equivalent).<br />
Fabrication of TTYCS series<br />
Braided shield Sheath Armor<br />
Make hole here, pull out core and<br />
cut off inclusion.<br />
L<br />
40 20<br />
8 - 10<br />
FS-<strong>15</strong>75T<br />
FS-<strong>2575</strong>T/FS-<strong>5075</strong>T<br />
Length of “L”<br />
190<br />
120<br />
60<br />
Set this part in cable clamp.<br />
20 30 20<br />
Crimp-on<br />
lug<br />
Tape entire<br />
shield<br />
Vinyl tape<br />
25
Change language