instruction manual - Hangar 9
instruction manual - Hangar 9
instruction manual - Hangar 9
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Section 3: Hinging The Rudder And Elevator<br />
Parts Needed<br />
Horizontal Stabilizer with Elevator and Hinges<br />
Vertical Stabilizer with Rudder and Hinges<br />
Tools Needed<br />
CA Remover<br />
Paper Towels<br />
Thin Instant CA Glue<br />
❑ 1.<br />
Push the elevator and horizontal stabilizer together until<br />
there is a constant 1/16” gap between the two and the<br />
edges are lined up correctly.<br />
❑ 4.<br />
Wipe off any excess CA using CA remover and a paper<br />
towel. Set these assemblies aside for now.<br />
❑ 2.<br />
❑ 3.<br />
Deflect the elevator and apply thin CA glue at the<br />
hinges so that it absorbs both into the stabilizer and the<br />
elevator (4 places).<br />
Using the same technique, hinge the rudder to the<br />
vertical stabilizer.<br />
Note:<br />
After CA has dried completely, check to ensure that the<br />
hinges are secured by pulling firmly on the control<br />
surfaces.<br />
13