instruction manual - Hangar 9

More documents

Recommendations

Info

Section 4: Installing The Aileron Servo Trays ❑ 11. Place the aileron tray, glue side down, on the exposed wood area on the bottom of the wing and gently press it into position. Use masking tape if necessary to hold in position until dry. Allow 15 minutes for the epoxy to cure. CONTINUED ❑ 13. Locate the wing center tape (white adhesive-backed tape) and remove the adhesive backing. Starting at the edge of the aileron tray, apply the tape around the wing at the center section, ending at the other side of the tray. Use a hobby knife to trim the excess length of tape. Your wing is now complete. ❑ 12. Using a sharp hobby knife, carefully cut out the balsa wood from the inside section of the aileron tray and remove. ❑ 14. Locate the small blue decal (square in shape) on the decal sheet included with your kit. Apply this decal to the leading edge of the wing to cover the wing center tape that you have just applied. Press firmly to ensure that the decal adheres properly to the wing. 16
Section 5: Assembling The Fuselage Parts Needed Fuselage Main Landing Gear (2 pcs) Main Landing Gear Hardware Wheels (2 pcs) Wheel Collars with Screws (2 pcs) Tools Needed Drill with 1/16” Drill Bit #1 and #2 Phillips Screwdrivers Thread Lock ❑ 1. Locate the main landing gear slot in the bottom of the fuselage. Position the two landing gear straps across the slot as shown and drill four 1/16” holes using the straps as a guide. Remove the straps after all four holes are drilled. ❑ 3. Reposition the landing gear straps over the 1/16” hole you drilled in Step 1. Screw into position with the four sheet metal screws provided. ❑ 2. Locate the two main landing gear struts and insert them into the landing gear slot as shown. Make sure the ends fit into the holes in the edges of the slot. ❑ 4. Place the wheels on the ends of the struts and secure them with the supplied wheel collars. Use thread lock on the collar screws. 17
Page 1 and 2: TM HANGAR 9 INSTRUCTION MANUAL Spec
Page 3 and 4: Table Of Contents Introduction 3 Co
Page 5 and 6: Contents Of Kit B E C D A A. Fusela
Page 7 and 8: Field Equipment Required HAN3000 -
Page 9 and 10: Section 1: Assembling The Wings Par
Page 11 and 12: Section 2: Joining The Wing Halves
Page 13 and 14: Section 3: Hinging The Rudder And E
Page 15: Section 4: Installing The Aileron S
Page 19 and 20: Section 7: Installing The Wing Dowe
Page 21 and 22: Section 8: Assembling The Fuel Tank
Page 23 and 24: Section 10: Installing The Control
Page 25 and 26: Section 11: Installing The Horizont
Page 27 and 28: Section 12: Installing The Engine P
Page 29 and 30: Section 12: Installing The Engine C
Page 31 and 32: Section 13: Installing The Radio In
Page 33 and 34: Section 14: Installing The Linkages
Page 39 and 40: Section 15: Setting Up The Radio Pa
Page 41 and 42: Pre-Flight Check ❑ 1. Check that
Page 43 and 44: Flight Instructions For first time
Page 45 and 46: Glossary Adverse Yaw. Some airplane
Page 48 and 49: ELEVATOR THROW GAUGE EASY FLY 40 HI

instruction manual - Hangar 9

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?